> > Yes, I am using ifconfig -a option. but it is not showing any usb0
device.
> > Currently I am experimenting on single PC. with no cable connected to
any
> > ports. I am able to successfully load all the necessory modules. lsmod
> > shows usage count 0.
> >
> > What can be the possible reasons for not showing usb0 ?
> UTSL.
>
> How about you provide some of the information you have:
> contents of /proc/bus/usb/devices
T: Bus=01 Lev=00 Prnt=00 Port=00 Cnt=00 Dev#= 1 Spd=12 MxCh= 2
B: Alloc= 0/900 us ( 0%), #Int= 0, #Iso= 0
D: Ver= 1.00 Cls=09(hub ) Sub=00 Prot=00 MxPS= 8 #Cfgs= 1
P: Vendor=0000 ProdID=0000 Rev= 0.00
S: Product=USB UHCI Root Hub
S: SerialNumber=d000
C:* #Ifs= 1 Cfg#= 1 Atr=40 MxPwr= 0mA
I: If#= 0 Alt= 0 #EPs= 1 Cls=09(hub ) Sub=00 Prot=00 Driver=hub
E: Ad=81(I) Atr=03(Int.) MxPS= 8 Ivl=255ms
> contents of /proc/bus/usb/drivers
usbdevfs
hub
usbnet
> dmesg output when you plug in the device
As I said previously, I am experimentin on single PC. Is that the problem ?
Is it like that, I have to connect the USB cable to the Other host and then
only the ifconfig -a command will show the device ?
> output of ifconfig -a
eth0 Link encap:Ethernet HWaddr 00:C0:26:2F:00:69
inet addr:192.168.10.11 Bcast:192.168.10.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:7157 errors:0 dropped:0 overruns:0 frame:0
TX packets:3736 errors:0 dropped:0 overruns:0 carrier:0
collisions:60 txqueuelen:100
Interrupt:11 Base address:0xb000
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:32 errors:0 dropped:0 overruns:0 frame:0
TX packets:32 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
_______________________________________________
[EMAIL PROTECTED]
To unsubscribe, use the last form field at:
https://lists.sourceforge.net/lists/listinfo/linux-usb-devel
