Hi, When I plug a device into my system, I have it load the firmware to it. The problem is that the firware tells the device to renumerate itself and show up as a different vend/prod id. That is fine, but when it does the renumeration, it removes the old device (pre-firmware) and does not send a new "add" message to user space or a "remove" when it is unplugged. The device is able to be used (from what I can tell thus far) if the bus is manually scanned for the new filename, but I would benefit from an add/remove signal to userspace just as if it were recently un/plugged. Is this supposed to happen on renumeration?
- bryan ------------------------------------------------------- This sf.net email is sponsored by:ThinkGeek Welcome to geek heaven. http://thinkgeek.com/sf _______________________________________________ [EMAIL PROTECTED] To unsubscribe, use the last form field at: https://lists.sourceforge.net/lists/listinfo/linux-usb-devel
