On Wed, Jan 08, 2003 at 08:01:00AM -0800, Ty Bekiares wrote: > I managed to get whiteheat driver working on my > embedded PPC823E platform. I'm communicating on two of > the ports on the WhiteHeat board. I can run > full-duplex 45kbps data through one of the ports for > about 4 hours before I get the same kernel oops > message (ksymoops output attached below). This happens > consistently, and the stack trace of the oops is > always the same. Here are the specifics of my setup: > > * processor: PPC 823E > * kernel version: 2.4.19-pre7 > * usb host controller driver: m8xxhci v1.3 > * usbserial version: stock 2.4.19 + connecttech v2.58 > patches > * whiteheat version: stock 2.4.19 + connecttech v2.58 > patches > * 1 serial port is set to 115kbps and is connected to > a user-mode program > * the other serial port is set to 230kbps and is > connected to the SLIP driver > > Below is the output of ksymoops. I haven't tried > looking at the usbserial/whiteheat verbode debugging > at the time of failure since my debug.log file is > currently stored on my volatile ramdisk. I'll move it > to flash and see if there is anything strange there. > In the mean time, does anyone have any thoughts as to > what might be happening:
Hm, no I don't. Have you tried emailing [EMAIL PROTECTED] with this info? He's the current maintainer of the driver. thanks, greg k-h ------------------------------------------------------- This SF.NET email is sponsored by: SourceForge Enterprise Edition + IBM + LinuxWorld = Something 2 See! http://www.vasoftware.com _______________________________________________ [EMAIL PROTECTED] To unsubscribe, use the last form field at: https://lists.sourceforge.net/lists/listinfo/linux-usb-devel
