On Wednesday 10 September 2003 18:12, Alan Stern wrote:
> On Wed, 10 Sep 2003, Duncan Sands wrote:
> > Hi all, in 2.6 a flag is set on device disconnect that causes any
> > future urb submissions to fail.  Then all pending urbs are "nuked".
> > This sounds great (especially if you want to "fire and forget" your
> > urbs), but does it actually work?  For example, uhci-hcd does not
> > seem to implement the disable method, so as far as I can see
> > "nuking" doesn't actually do anything much - or am I confused?
>
> You're a little confused.  The disable() method that the "nuke" routine
> uses actually lives in core/hcd.c.  It unlinks all the matching URBs and
> then calls the HCD's disable().  UHCI doesn't have one because it doesn't
> need to do anything to the hardware once the URBs are unlinked.  (However
> a bug did turn up recently: disable() needs to wait until the unlink
> finishes.  One of my recent -- not yet applied -- patches does that.)
>
> > I would like to be confident that urb unlinking in a disconnect
> > method is pointless - because the urbs have already been nuked.
> > Is that right?
>
> It might be better for your driver to keep track of the status of each
> URB.  Whenever a completion routine is called, it can note that the URB is
> inactive.  Then your disconnect handler can try to unlink any URBs that
> are still active -- presumably there won't be any but it doesn't hurt to
> make sure.

Hi Alan, thanks for your email.  I have a firmware loading routine that
fires a series of bulk urbs to the device.  Rather than adding a semaphore
and flags to check for disconnect, it would be nice to just take a reference
to the usb device and ignore disconnection.  But it seems that that is not
yet possible.  Any reason the core doesn't wait for the urbs its nuked to
complete before calling the disconnect routine?

Ciao,

Duncan.


-------------------------------------------------------
This sf.net email is sponsored by:ThinkGeek
Welcome to geek heaven.
http://thinkgeek.com/sf
_______________________________________________
[EMAIL PROTECTED]
To unsubscribe, use the last form field at:
https://lists.sourceforge.net/lists/listinfo/linux-usb-devel

Reply via email to