I am trying to get my new Sony DSC-p10 digital camera working on a RH 9
distro. I only found one article in the archives about this problem, Greg suggesting
that it should be ok with the 2.6 kernel. I have downloaded the test-11 version, compiled it,
and gotten it to boot (I am running that kernal now, as I write you), but the camera still
will not mount.
The camera shows up in /proc/bus/usb/devices. When I try mount -t vfat /dev/sda /mnt/camera, I get the following error: /dev/sda is not a valid block device
I get the same error when I try to mount it from fstab, which has the following entry: /dev/sda /mnt/camera auto noauto,user 0 0
Same results when I try /dev/sda1 and /dev/sda2
Searching the archives did show that in many cases, one must modify the
"unusual devices.h" file. The reason for this seems to be that the unusual devices
macro takes an arguement indicating the highest product number for which
the rest of the code should apply. For some reason, the 2.4 kernel has 0x0210 as the highest
revision number, so any camera with rev number greater than this fails.
On the 2.6 kernel, however (at least the version I have), the high end is 0x0450. I checked in
/proc/bus/usb/devices, and this is the rev number for my camera. Thus (I am guessing) it should
be ok, and no modification of "unusual_devices.h" is required.
I thought that the problem might be that I use a memory stick pro, 256MB, but I get the same
failure with a standard memory stick (32MB).
Does anyone have any ideas?
Below I am attaching all of the outputs one is generally supposed to send with
help requests.
Thank you for your time and any help you might offer
glenn lawyer
The section of /proc/bus/usb/devices with the camera:
T: Bus=02 Lev=01 Prnt=01 Port=00 Cnt=01 Dev#= 2 Spd=12 MxCh= 0 D: Ver= 1.10 Cls=00(>ifc ) Sub=00 Prot=00 MxPS= 8 #Cfgs= 1 P: Vendor=054c ProdID=0010 Rev= 4.50 S: Manufacturer=Sony S: Product=Sony DSC C:* #Ifs= 1 Cfg#= 1 Atr=c0 MxPwr= 2mA I: If#= 0 Alt= 0 #EPs= 3 Cls=08(stor.) Sub=ff Prot=01 Driver=(none) E: Ad=01(O) Atr=02(Bulk) MxPS= 64 Ivl=0ms E: Ad=82(I) Atr=02(Bulk) MxPS= 64 Ivl=0ms E: Ad=83(I) Atr=03(Int.) MxPS= 8 Ivl=255ms
/root:)lspci -v
00:00.0 Host bridge: VIA Technologies, Inc. VT8366/A/7 [Apollo KT266/A/333]
Flags: bus master, 66Mhz, medium devsel, latency 0
Memory at e0000000 (32-bit, prefetchable) [size=128M]
Capabilities: [a0] AGP version 2.0
Capabilities: [c0] Power Management version 200:01.0 PCI bridge: VIA Technologies, Inc. VT8366/A/7 [Apollo
KT266/A/333 AGP] (prog-if 00 [Normal decode])
Flags: bus master, 66Mhz, medium devsel, latency 0
Bus: primary=00, secondary=01, subordinate=01, sec-latency=0
Capabilities: [80] Power Management version 200:08.0 Ethernet controller: 3Com Corporation 3c905C-TX/TX-M [Tornado]
(rev 78)
Subsystem: 3Com Corporation 3C905C-TX Fast Etherlink for PC
Management NIC
Flags: bus master, medium devsel, latency 32, IRQ 11
I/O ports at d000 [size=128]
Memory at ec008000 (32-bit, non-prefetchable) [size=128]
Expansion ROM at <unassigned> [disabled] [size=128K]
Capabilities: [dc] Power Management version 200:09.0 Multimedia audio controller: Yamaha Corporation YMF-724 (rev 03)
Subsystem: Yamaha Corporation YMF724-Based PCI Audio Adapter
Flags: bus master, medium devsel, latency 32, IRQ 11
Memory at ec000000 (32-bit, non-prefetchable) [size=32K]
Capabilities: [50] Power Management version 100:0b.0 VGA compatible controller: nVidia Corporation NV5 [RIVA
TNT2/TNT2 Pro] (rev 15) (prog-if 00 [VGA])
Subsystem: Asustek Computer, Inc. PCI-V3800
Flags: bus master, 66Mhz, medium devsel, latency 32, IRQ 10
Memory at ea000000 (32-bit, non-prefetchable) [size=16M]
Memory at e8000000 (32-bit, prefetchable) [size=32M]
Expansion ROM at <unassigned> [disabled] [size=64K]
Capabilities: [60] Power Management version 100:10.0 USB Controller: VIA Technologies, Inc. USB (rev 80) (prog-if 00
[UHCI])
Subsystem: VIA Technologies, Inc. USB
Flags: bus master, medium devsel, latency 32, IRQ 11
I/O ports at d400 [size=32]
Capabilities: [80] Power Management version 200:10.1 USB Controller: VIA Technologies, Inc. USB (rev 80) (prog-if 00
[UHCI])
Subsystem: VIA Technologies, Inc. USB
Flags: bus master, medium devsel, latency 32, IRQ 11
I/O ports at d800 [size=32]
Capabilities: [80] Power Management version 200:10.2 USB Controller: VIA Technologies, Inc. USB (rev 80) (prog-if 00
[UHCI])
Subsystem: VIA Technologies, Inc. USB
Flags: bus master, medium devsel, latency 32, IRQ 5
I/O ports at dc00 [size=32]
Capabilities: [80] Power Management version 200:10.3 USB Controller: VIA Technologies, Inc. USB 2.0 (rev 82) (prog-if
20 [EHCI])
Subsystem: VIA Technologies, Inc. USB 2.0
Flags: bus master, medium devsel, latency 32, IRQ 10
Memory at ec009000 (32-bit, non-prefetchable) [size=256]
Capabilities: [80] Power Management version 200:11.0 ISA bridge: VIA Technologies, Inc. VT8235 ISA Bridge
Subsystem: VIA Technologies, Inc. VT8235 ISA Bridge
Flags: bus master, stepping, medium devsel, latency 0
Capabilities: [c0] Power Management version 200:11.1 IDE interface: VIA Technologies, Inc. VT82C586/B/686A/B PIPC Bus
Master IDE (rev 06) (prog-if 8a [Master SecP PriP])
Subsystem: VIA Technologies, Inc. VT8235 Bus Master
ATA133/100/66/33 IDE
Flags: bus master, medium devsel, latency 32
I/O ports at e000 [size=16]
Capabilities: [c0] Power Management version 200:11.5 Multimedia audio controller: VIA Technologies, Inc. VT8233 AC97
Audio Controller (rev 50)
Subsystem: Unknown device 1695:3005
Flags: medium devsel, IRQ 5
I/O ports at e400 [size=256]
Capabilities: [c0] Power Management version 2~/linux-2.6.0-test11 :)cat /proc/version
Linux version 2.6.0-test11 ([EMAIL PROTECTED]) (gcc version 3.2.2 20030222 (Red Hat Linux 3.2.2-5)) #3 Thu Dec 4 21:17:25 EST 2003
~/linux-2.6.0-test11 :)cat /proc/cpuinfo processor : 0 vendor_id : AuthenticAMD cpu family : 6 model : 6 model name : AMD Athlon(tm) XP 1600+ stepping : 2 cpu MHz : 1403.835 cache size : 256 KB fdiv_bug : no hlt_bug : no f00f_bug : no coma_bug : no fpu : yes fpu_exception : yes cpuid level : 1 wp : yes flags : fpu vme de pse tsc msr pae mce cx8 apic sep mtrr pge mca cmov pat pse36 mmx fxsr sse syscall mp mmxext 3dnowext 3dnow bogomips : 2760.70
~/linux-2.6.0-test11 :)cat /proc/modules binfmt_misc 10120 - - Live 0xf8912000 autofs 15616 - - Live 0xf88fe000 ohci1394 34464 - - Live 0xf8936000 ieee1394 81324 - - Live 0xf894e000 parport_pc 26920 - - Live 0xf880f000 parport 42656 - - Live 0xf8906000 ide_scsi 14820 - - Live 0xf88f3000 scsi_mod 117572 - - Live 0xf8918000 ide_cd 40512 - - Live 0xf88dd000 cdrom 34880 - - Live 0xf88e9000 hid 24736 - - Live 0xf8818000
~/linux-2.6.0-test11 :)cat /proc/ioports 0000-001f : dma1 0020-0021 : pic1 0040-005f : timer 0060-006f : keyboard 0070-0077 : rtc 0080-008f : dma page reg 00a0-00a1 : pic2 00c0-00df : dma2 00f0-00ff : fpu 0170-0177 : ide1 01f0-01f7 : ide0 0376-0376 : ide1 0378-037a : parport0 03c0-03df : vga+ 03f6-03f6 : ide0 0cf8-0cff : PCI conf1 d000-d07f : 0000:00:08.0 d000-d07f : 0000:00:08.0 d400-d41f : 0000:00:10.0 d400-d41f : uhci_hcd d800-d81f : 0000:00:10.1 d800-d81f : uhci_hcd dc00-dc1f : 0000:00:10.2 dc00-dc1f : uhci_hcd e000-e00f : 0000:00:11.1 e000-e007 : ide0 e008-e00f : ide1 e400-e4ff : 0000:00:11.5
~/linux-2.6.0-test11 :)cat /proc/iomem 00000000-0009fbff : System RAM 0009fc00-0009ffff : reserved 000a0000-000bffff : Video RAM area 000d0000-000d07ff : Extension ROM 000f0000-000fffff : System ROM 00100000-4ffeffff : System RAM 00100000-002c23b7 : Kernel code 002c23b8-0037713f : Kernel data 4fff0000-4fff2fff : ACPI Non-volatile Storage 4fff3000-4fffffff : ACPI Tables e0000000-e7ffffff : 0000:00:00.0 e8000000-e9ffffff : 0000:00:0b.0 ea000000-eaffffff : 0000:00:0b.0 ec000000-ec007fff : 0000:00:09.0 ec008000-ec00807f : 0000:00:08.0 ec009000-ec0090ff : 0000:00:10.3 ec009000-ec0090ff : ehci_hcd fec00000-fec00fff : reserved fee00000-fee00fff : reserved ffff0000-ffffffff : reserved
~/linux-2.6.0-test11 :)cat /proc/scsi/scsi Attached devices: Host: scsi0 Channel: 00 Id: 00 Lun: 00 Vendor: ATAPI Model: CD-R/RW 24X10 Rev: P.GJ Type: CD-ROM ANSI SCSI revision: 02
--
I want to go farther, farther!
A. E. L.
------------------------------------------------------- This SF.net email is sponsored by: IBM Linux Tutorials. Become an expert in LINUX or just sharpen your skills. Sign up for IBM's Free Linux Tutorials. Learn everything from the bash shell to sys admin. Click now! http://ads.osdn.com/?ad_id=1278&alloc_id=3371&op=click _______________________________________________ [EMAIL PROTECTED] To unsubscribe, use the last form field at: https://lists.sourceforge.net/lists/listinfo/linux-usb-devel
