Hi,all
I'm now doing the OHCD migration on a board based on
ColdFire.Only port2 is used.
The HcRhDescriptorA is set 0xff000a02.
The interrupt is attached successfully.After the ohc's
intialization,the HcRhPortStatus[2] shows one device is
attached,while there is no device attached at all.The value of this
register is 0x309 at last.The actual changes of the register value is
0x80108->0x90309->0x80309->0x309.
And when a device is attached,the HcRhPortStatus[2] changes to 0x10108.
Yes,that is not correct.Is it because of the over_current?Or any
other reason?
Appeciated for your guidance.
Best regards,
Jason
-------------------------------------------------------------------------
Take Surveys. Earn Cash. Influence the Future of IT
Join SourceForge.net's Techsay panel and you'll get the chance to share your
opinions on IT & business topics through brief surveys -- and earn cash
http://www.techsay.com/default.php?page=join.php&p=sourceforge&CID=DEVDEV
_______________________________________________
[email protected]
To unsubscribe, use the last form field at:
https://lists.sourceforge.net/lists/listinfo/linux-usb-users
