Hi;
I'm running RH 2.2.18 kernel on a P100 Acer with a PCI USB card.
The output of /proc/pci is as follows;
<---------------------------------------------------
snip-----------------------------------------------------------------------
------->
Bus 0, device 15, function 0:
USB Controller: CMD 670 (rev 6).
Medium devsel. Master Capable. Latency=96. Min Gnt=2.Max Lat=4.
Non-prefetchable 32 bit memory at 0x4000000 [0x4000000].
<--------------------------------------------------------------------------
---------------------------------------------------------------->
I can load the usbcore module successfully however I get the following
output in the /var/log/messages file when doing a insmod usb-ohci;
<---------------------------------------------------
snip-----------------------------------------------------------------------
------->
Apr 4 20:50:28 pps kernel: usb-ohci.c: USB OHCI at membase 0xc383f000, IRQ
0
Apr 4 20:50:28 pps kernel: usb.c: new USB bus registered, assigned bus
number 1
Apr 4 20:50:28 pps kernel: usb-ohci.c: request interrupt 0 failed
Apr 4 20:50:28 pps kernel: usb.c: USB bus 1 deregistered
<--------------------------------------------------------------------------
---------------------------------------------------------------->
Is there a way I can change the IRQ or is there a patch for this problem.
I'm at sea on this one.
Any help greatly appreciated. Thanks in advance.
rgds
Phil
_______________________________________________
[EMAIL PROTECTED]
To unsubscribe, use the last form field at:
http://lists.sourceforge.net/lists/listinfo/linux-usb-users
