|
Still trying to get an external USB enclosure to
work. I worked out the power issue and am addressing the timing of the
drive being ready manually. The issue I will have is as
follows:
- apply power to the drive ; give
it a chance to spin up and be ready
- attach the USB cable and get
the following
from /var/log/messages:
Jan 14
12:02:38 pbelk kernel: hub.c: USB new device connect on bus1/2/2, assigned
device number 5
Jan 14 12:02:38 pbelk kernel: usb.c: USB device 5 (vend/prod
0x67b/0x2307) is not claimed by any active driver.
Jan 14 12:02:38 pbelk
/etc/hotplug/usb.agent: ... no drivers for USB product
67b/2307/100
from
cat /proc/bus/usb/devices:
:*
#Ifs= 1 Cfg#= 1 Atr=e0 MxPwr=100mA
I:
If#= 0 Alt= 0 #EPs= 1 Cls=09(hub
) Sub=00 Prot=00 Driver=hub
E:
Ad=81(I) Atr=03(Int.) MxPS=
1 Ivl=255ms
T: Bus=01
Lev=02 Prnt=02 Port=01 Cnt=01 Dev#=
5 Spd=12 MxCh= 0
D: Ver= 1.00 Cls=00(>ifc ) Sub=00
Prot=00 MxPS= 8 #Cfgs= 1
P: Vendor=067b ProdID=2307 Rev=
1.00
S: Manufacturer=Prolific
Technology Inc.
S:
Product=ATAPI-4 Bridge Controller
S: SerialNumber=0
C:* #Ifs= 1 Cfg#= 1
Atr=a0 MxPwr=100mA
I: If#= 0
Alt= 0 #EPs= 3 Cls=ff(vend.) Sub=ff Prot=ff Driver=(none)
E: Ad=01(O) Atr=02(Bulk) MxPS= 64 Ivl= 0ms
E: Ad=82(I) Atr=02(Bulk) MxPS= 64 Ivl= 0ms
E: Ad=83(I) Atr=03(Int.) MxPS= 7 Ivl= 1ms
So I can determine the Vendor ID: 067b
the Product ID: 2307 and the Revision: 1.00. How do I specify
the kernel to use the usb-storage driver for it? Will it work at
all?
TIA
-- Paul
|
