It is on the same disk I ran the install from.
-----Original Message----- From: Stephen J. Gowdy [mailto:[EMAIL PROTECTED]] Sent: Saturday, February 09, 2002 1:17 PM To: Ritchie Lau Cc: [EMAIL PROTECTED] Subject: RE: [Linux-usb-users] Linksys WUSB11 v2.5 Did you download the linux source for the same version you are running? On Sat, 9 Feb 2002, Ritchie Lau wrote: > > I downloaded and untared the driver from linksys. > Followed their README instructions to make clean, make config and > make install. Initially I didn't have the kernel source to get pass > the make config so I installed the source via GNOMERPM from the 2nd RH7.2 > cdrom. The instructions says then to plug in the usb device, run modprobe > and there's where my error stands today. Subsequent steps were to run > ifconfig wlan0 up, wlanctl-ng e.g. to set ssid, IP ... > > > > -----Original Message----- > From: Stephen J. Gowdy [mailto:[EMAIL PROTECTED]] > Sent: Saturday, February 09, 2002 12:57 PM > To: Ritchie Lau > Cc: [EMAIL PROTECTED] > Subject: RE: [Linux-usb-users] Linksys WUSB11 v2.5 > > > How did you build the module? > > On Sat, 9 Feb 2002, Ritchie Lau wrote: > > > > > AFAIK, it is a straight vanilla RH7.2. > > I mkdir a usb folder in the 2.4.7-10 and copied prism_usb.o there. > > depmod gave me unresolved symbols also. > > modprobe now gives me the same errors as well. > > > > I'm missing something... > > > > Still hope? ...R > > > > > > -----Original Message----- > > From: Stephen J. Gowdy [mailto:[EMAIL PROTECTED]] > > Sent: Saturday, February 09, 2002 12:27 PM > > To: Ritchie Lau > > Cc: [EMAIL PROTECTED] > > Subject: RE: [Linux-usb-users] Linksys WUSB11 v2.5 > > > > > > Is it a custom one? If not copy it to the normal place (under 2.4.7-10) > > and then run depmod and try the modprobe again. > > > > On Sat, 9 Feb 2002, Ritchie Lau wrote: > > > > > > > > The linksys config stuck it in there stating my kernel source is a > custom > > > one. > > > Insmod gave me a bunch of unresolved symbols. > > > > > > Thanks but any other ideas? ...R > > > > > > -----Original Message----- > > > From: Stephen J. Gowdy [mailto:[EMAIL PROTECTED]] > > > Sent: Saturday, February 09, 2002 10:03 AM > > > To: Ritchie Lau > > > Cc: [EMAIL PROTECTED] > > > Subject: Re: [Linux-usb-users] Linksys WUSB11 v2.5 > > > > > > > > > Why did it put them there instead of /lib/modules/2.4.7-10? Have you > tried > > > "insmod /lib/modules/2.4.7-10custom/usb/prism2_usb.o"? > > > > > > On Sat, 9 Feb 2002, Ritchie Lau wrote: > > > > > > > > > > > I'm a Linux newbie. It's now Feb '02 and I haven't seen any threads > > > > on getting my Linksys USB wlan to work. The 'unsupported' Linux > driver > > I > > > > got from Linksys errors out at modprobe prism2_usb saying the > prism2_usb > > > > module is not found. I see prism2_usb.o there in > > > > /lib/modules/2.4.7-10custom/usb. > > > > > > > > My /proc/bus/usb/devices shows my mouse and even my usb memory stick > > > > reader but nothing about the Linksys usb wlan. > > > > > > > > Any ideas. Thanks. ...R > > > > > > > > Redhat 7.2 with 2.4.7.10 kernel > > > > Linksys WUSB11 v2.5 > > > > > > > > > > > > [EMAIL PROTECTED] > > > > > > > > > > > > > > > > _______________________________________________ > > > > [EMAIL PROTECTED] > > > > To unsubscribe, use the last form field at: > > > > https://lists.sourceforge.net/lists/listinfo/linux-usb-users > > > > > > > > > > -- > > > /------------------------------------+-------------------------\ > > > |Stephen J. Gowdy | SLAC, MailStop 34, | > > > |http://www.slac.stanford.edu/~gowdy/ | 2575 Sand Hill Road, | > > > | | Menlo Park CA 94025, USA | > > > |EMail: [EMAIL PROTECTED] | Tel: +1 650 926 3144 | > > > \------------------------------------+-------------------------/ > > > > > > > > > > -- > > /------------------------------------+-------------------------\ > > |Stephen J. Gowdy | SLAC, MailStop 34, | > > |http://www.slac.stanford.edu/~gowdy/ | 2575 Sand Hill Road, | > > | | Menlo Park CA 94025, USA | > > |EMail: [EMAIL PROTECTED] | Tel: +1 650 926 3144 | > > \------------------------------------+-------------------------/ > > > > > > -- > /------------------------------------+-------------------------\ > |Stephen J. Gowdy | SLAC, MailStop 34, | > |http://www.slac.stanford.edu/~gowdy/ | 2575 Sand Hill Road, | > | | Menlo Park CA 94025, USA | > |EMail: [EMAIL PROTECTED] | Tel: +1 650 926 3144 | > \------------------------------------+-------------------------/ > > -- /------------------------------------+-------------------------\ |Stephen J. Gowdy | SLAC, MailStop 34, | |http://www.slac.stanford.edu/~gowdy/ | 2575 Sand Hill Road, | | | Menlo Park CA 94025, USA | |EMail: [EMAIL PROTECTED] | Tel: +1 650 926 3144 | \------------------------------------+-------------------------/ _______________________________________________ [EMAIL PROTECTED] To unsubscribe, use the last form field at: https://lists.sourceforge.net/lists/listinfo/linux-usb-users
