Hello All. I'm trying to setup a USB SmartMedia card reader. I don't believe that my USB is working correctly though. I have UHCI support compiled into my kernel.
dmesg contains the following: usb_control/bulk_msg: timeout usb.c: USB device not accepting new address=2 (error=-110) hub.c: port 2, portstatus 103, change 0, 12 Mb/s hub.c: USB new device connect on bus1/2, assigned device number 3 usb_control/bulk_msg: timeout usb.c: USB device not accepting new address=3 (error=-110) hub.c: port 1 connection change hub.c: port 1, portstatus 100, change 3, 12 Mb/s hub.c: port 2 connection change hub.c: port 2, portstatus 300, change 3, 1.5 Mb/s hub.c: port 1 enable change, status 300 hub.c: port 1 enable change, status 100 hub.c: port 2 enable change, status 300 I'm not even quite sure where to start. I have an AOPEN AK73-1394 motherboard, if that's any help. Any help would be greatly appreciated. Thank you. --Patrick _______________________________________________ [EMAIL PROTECTED] To unsubscribe, use the last form field at: https://lists.sourceforge.net/lists/listinfo/linux-usb-users
