hi, has someone successfully installed/used the multicard reader in subject? (winward 6in1 USB)
I enabled multi-lun support to recognize the two slots and I use 2.4.18-19.8.0 kernel (installed with a RedHat update package) Reader devices are recognized but the built in HUB seems to have problem to be recognized and I can't access any media inserted into the reader. The device is listed in proc/scsi and all modules needed are loaded. this is what I can see from /var/log/messages when the device is plugged to the USB port. [paste] kernel: hub.c: connect-debounce failed, port 2 isabled kernel: hub.c: USB new device connect on bus1/2, assigned device number kernel: usb.c: USB device 3 (vend/prod 0x7cc/0x201) is not claimed by any active driver. /etc/hotplug/usb.agent: Setup usb-storage for USB product 7cc/201/12 kernel: Initializing USB Mass Storage driver... kernel: usb.c: registered new driver usb-storage kernel: scsi1 : SCSI emulation for USB Mass Storage devices kernel: Vendor: SPRING Model: MultiCard Slot A Rev: 0100 kernel: Type: Direct-Access ANSI SCSI revision: 02 kernel: Vendor: SPRING Model: MultiCard Slot C Rev: 0100 kernel: Type: Direct-Access ANSI SCSI revision: 02 kernel: Attached scsi removable disk sda at scsi1, channel 0, id 0, lun 0 kernel: Attached scsi removable disk sdb at scsi1, channel 0, id 0, lun 1 kernel: SCSI device sda: 1515870810 512-byte hdwr sectors (-323385 MB) kernel: sda: Write Protect is off kernel: sda:<6>usb.c: USB disconnect on device 3 kernel: hub.c: USB new device connect on bus1/2, assigned device number 4 kernel: usb-uhci.c: interrupt, status 3, frame# 403 kernel: scsi: device set offline - not ready or command retry failed after bus reset: host 1 channel 0 id 0 lun 0 kernel: SCSI disk error : host 1 channel 0 id 0 lun 0 return code = 70000 kernel: I/O error: dev 08:00, sector 0 kernel: I/O error: dev 08:00, sector 2 kernel: I/O error: dev 08:00, sector 0 kernel: unable to read partition table [end] in this example no media was in the reader when plugged. Modules loaded: usb-storage 62064 1 (initializing) usb-uhci 26188 0 (unused) usbcore 77024 1 [usb-storage hid usb-uhci] scsi_mod 107176 4 [usb-storage sr_mod aic7xxx sd_mod] any suggetion to let it work? thanks in advance -Alessio Bravi -- Alessio Bravi <[EMAIL PROTECTED]> ------------------------------------------------------- This SF.NET email is sponsored by: SourceForge Enterprise Edition + IBM + LinuxWorld = Something 2 See! http://www.vasoftware.com _______________________________________________ [EMAIL PROTECTED] To unsubscribe, use the last form field at: https://lists.sourceforge.net/lists/listinfo/linux-usb-users
