Hi Matt, How can i access the drive? It does not show me where to mount it from!
I tried it again yesterday night and it was properly detected, it asked me to mount it from /dev/sda1 and i could read/write. But today morning again the same problem Any reasons? Regards Aditya On Sat, 19 Mar 2005 20:21:19 -0800, Matthew Dharm <[EMAIL PROTECTED]> wrote: > I see no errors in your posting. > > However, it appears that you did not attempt to access the device. > > Matt > > On Sun, Mar 20, 2005 at 09:02:13AM +0530, ThinRhino wrote: > > Hi > > > > I am using the kernel 2.6.11.2 and i am not able to mount my pen dirve > > or thumb drive. I am posting the output of dmesg below. > > > > Any help will be appreciated > > > > Cheers > > ThinRhino > > > > ===================== > > dmesg output > > ===================== > > > > hub 1-0:1.0: state 5 ports 6 chg 0000 evt 0002 > > ehci_hcd 0000:00:1d.7: GetStatus port 1 status 001803 POWER sig=j CSC > > CONNECT > > hub 1-0:1.0: port 1, status 0501, change 0001, 480 Mb/s > > hub 1-0:1.0: debounce: port 1: total 100ms stable 100ms status 0x501 > > ehci_hcd 0000:00:1d.7: port 1 high speed > > ehci_hcd 0000:00:1d.7: GetStatus port 1 status 001005 POWER sig=se0 PE > > CONNECT > > usb 1-1: new high speed USB device using ehci_hcd and address 2 > > ehci_hcd 0000:00:1d.7: port 1 high speed > > ehci_hcd 0000:00:1d.7: GetStatus port 1 status 001005 POWER sig=se0 PE > > CONNECT > > usb 1-1: new device strings: Mfr=1, Product=2, SerialNumber=3 > > usb 1-1: default language 0x0409 > > usb 1-1: Product: Flash Disk > > usb 1-1: Manufacturer: USB > > usb 1-1: SerialNumber: 611041D92C9200CE > > usb 1-1: hotplug > > usb 1-1: adding 1-1:1.0 (config #1, interface 0) > > usb 1-1:1.0: hotplug > > SCSI subsystem initialized > > Initializing USB Mass Storage driver... > > usb-storage 1-1:1.0: usb_probe_interface > > usb-storage 1-1:1.0: usb_probe_interface - got id > > usb-storage: USB Mass Storage device detected > > usb-storage: -- associate_dev > > usb-storage: Vendor: 0x0ea0, Product: 0x2168, Revision: 0x0200 > > usb-storage: Interface Subclass: 0x06, Protocol: 0x50 > > usb-storage: Vendor: USB , Product: Flash Disk > > usb-storage: Transport: Bulk > > usb-storage: Protocol: Transparent SCSI > > usb-storage: usb_stor_control_msg: rq=fe rqtype=a1 value=0000 index=00 > > len=1 > > usb-storage: GetMaxLUN command result is 1, data is 0 > > scsi0 : SCSI emulation for USB Mass Storage devices > > usbcore: registered new driver usb-storage > > USB Mass Storage support registered. > > usb-storage: *** thread sleeping. > > usb-storage: device found at 2 > > usb-storage: waiting for device to settle before scanning > > usb-storage: queuecommand called > > usb-storage: *** thread awakened. > > usb-storage: Command INQUIRY (6 bytes) > > usb-storage: 12 00 00 00 24 00 > > usb-storage: Bulk Command S 0x43425355 T 0x1 L 36 F 128 Trg 0 LUN 0 CL 6 > > usb-storage: usb_stor_bulk_transfer_buf: xfer 31 bytes > > usb-storage: Status code 0; transferred 31/31 > > usb-storage: -- transfer complete > > usb-storage: Bulk command transfer result=0 > > usb-storage: usb_stor_bulk_transfer_buf: xfer 36 bytes > > usb-storage: Status code 0; transferred 36/36 > > usb-storage: -- transfer complete > > usb-storage: Bulk data transfer result 0x0 > > usb-storage: Attempting to get CSW... > > usb-storage: usb_stor_bulk_transfer_buf: xfer 13 bytes > > usb-storage: Status code 0; transferred 13/13 > > usb-storage: -- transfer complete > > usb-storage: Bulk status result = 0 > > usb-storage: Bulk Status S 0x53425355 T 0x1 R 0 Stat 0x0 > > usb-storage: scsi cmd done, result=0x0 > > usb-storage: *** thread sleeping. > > Vendor: JetFlash Model: TS512MJF2B Rev: 2.00 > > Type: Direct-Access ANSI SCSI revision: 02 > > usb-storage: queuecommand called > > usb-storage: *** thread awakened. > > usb-storage: Bad target number (1:0) > > usb-storage: scsi cmd done, result=0x40000 > > usb-storage: *** thread sleeping. > > usb-storage: queuecommand called > > usb-storage: *** thread awakened. > > usb-storage: Bad target number (2:0) > > usb-storage: scsi cmd done, result=0x40000 > > usb-storage: *** thread sleeping. > > usb-storage: queuecommand called > > usb-storage: *** thread awakened. > > usb-storage: Bad target number (3:0) > > usb-storage: scsi cmd done, result=0x40000 > > usb-storage: *** thread sleeping. > > usb-storage: queuecommand called > > usb-storage: *** thread awakened. > > usb-storage: Bad target number (4:0) > > usb-storage: scsi cmd done, result=0x40000 > > usb-storage: *** thread sleeping. > > usb-storage: queuecommand called > > usb-storage: *** thread awakened. > > usb-storage: Bad target number (5:0) > > usb-storage: scsi cmd done, result=0x40000 > > usb-storage: *** thread sleeping. > > usb-storage: queuecommand called > > usb-storage: *** thread awakened. > > usb-storage: Bad target number (6:0) > > usb-storage: scsi cmd done, result=0x40000 > > usb-storage: *** thread sleeping. > > usb-storage: queuecommand called > > usb-storage: *** thread awakened. > > usb-storage: Bad target number (7:0) > > usb-storage: scsi cmd done, result=0x40000 > > usb-storage: *** thread sleeping. > > usb-storage: device scan complete > > > > > > > > ------------------------------------------------------- > > SF email is sponsored by - The IT Product Guide > > Read honest & candid reviews on hundreds of IT Products from real users. > > Discover which products truly live up to the hype. Start reading now. > > http://ads.osdn.com/?ad_id=6595&alloc_id=14396&op=click > > _______________________________________________ > > [email protected] > > To unsubscribe, use the last form field at: > > https://lists.sourceforge.net/lists/listinfo/linux-usb-users > > -- > Matthew Dharm Home: [EMAIL PROTECTED] > Maintainer, Linux USB Mass Storage Driver > > It was a new hope. > -- Dust Puppy > User Friendly, 12/25/1998 > > > ------------------------------------------------------- SF email is sponsored by - The IT Product Guide Read honest & candid reviews on hundreds of IT Products from real users. Discover which products truly live up to the hype. Start reading now. http://ads.osdn.com/?ad_id=6595&alloc_id=14396&op=click _______________________________________________ [email protected] To unsubscribe, use the last form field at: https://lists.sourceforge.net/lists/listinfo/linux-usb-users
