Hi Engineers,
Dear all:
When I use the g_file_strogae.ko module, I failed to write big file to the disk.
Hardware platform:
CPU: S3C2440A
SDRAM: 32M sdram
Kernel:2.6.19
processor:AT91SAM9261
I plug a 256MBytes usb flashdisk(fat32 type) into the board usb host
interface, and connect a usb line between the board usb device interface
and a PC with WinXP OS.
In the board side, I use the following command:
#> insmod ./g_file_storage.ko file=/dev/sda removable=1
where /dev/sda is the external 256MB flash disk.
Then in the PC side, XP can recognize the board as a usb mass storage
device. And read big file(3Mbytes) is OK.
But when I write a big file(3Mbytes) into the board from XP side, the
speed is very slow and finally failed. (Write a 3KBytes file is OK). In
the board side, kernel repeatedly printed following message every
several seconds. "g_file_storage gadget: full speed config #1".
What's wrong with it?
Regards,
M.Maheswaran
system Analyst
____________________________________________________________________________________
Yahoo! oneSearch: Finally, mobile search
that gives answers, not web links.
http://mobile.yahoo.com/mobileweb/onesearch?refer=1ONXIC
____________________________________________________________________________________
Pinpoint customers who are looking for what you sell.
http://searchmarketing.yahoo.com/
-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2005.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
[email protected]
To unsubscribe, use the last form field at:
https://lists.sourceforge.net/lists/listinfo/linux-usb-users
