Hi, I'm trying to get my HP Scanjet 6300C working under kernel 2.2.14
with the pre7-1 patch. I get the following messages when I install
the usb-uhci or uhci modules:
usb_control/bul_msg: timeout
I get this 4 times then:
usb.c: USB device not responding, giving up (error=-110)
I also get the same message if I compile the usb into the
kernel.
My Mother board is a Tyan Tomcat IV S1564D
2x p233 MMX
64 MB ram
Here is output from lspci:
00:00.0 Host bridge: Intel Corporation 430HX - 82439HX TXC [Triton II] (rev 03)
00:07.0 ISA bridge: Intel Corporation 82371SB PIIX3 ISA [Natoma/Triton II]
(rev 01)
00:07.1 IDE interface: Intel Corporation 82371SB PIIX3 IDE [Natoma/Triton II]
00:07.2 USB Controller: Intel Corporation 82371SB PIIX3 USB [Natoma/Triton
II] (rev 01)
00:12.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL-8029(AS)
00:13.0 VGA compatible controller: ATI Technologies Inc 3D Rage Pro (rev 5c)
Here is my /proc/bus/usb/devices file:
T: Bus=01 Lev=00 Prnt=00 Port=00 Cnt=00 Dev#= 1 Spd=12 MxCh= 2
B: Alloc= 0/900 us ( 0%), #Int= 0, #Iso= 0
D: Ver= 1.00 Cls=09(hub ) Sub=00 Prot=00 MxPS= 8 #Cfgs= 1
P: Vendor=0000 ProdID=0000 Rev= 0.00
S: Product=USB UHCI Root Hub
S: SerialNumber=6000
C:* #Ifs= 1 Cfg#= 1 Atr=40 MxPwr= 0mA
I: If#= 0 Alt= 0 #EPs= 1 Cls=09(hub ) Sub=00 Prot=00 Driver=hub
E: Ad=81(I) Atr=03(Int.) MxPS= 8 Ivl=255ms
T: Bus=01 Lev=01 Prnt=01 Port=00 Cnt=01 Dev#= -1 Spd=12 MxCh= 0
D: Ver= 1.00 Cls=00(>ifc ) Sub=00 Prot=00 MxPS= 8 #Cfgs= 0
P: Vendor=0000 ProdID=0000 Rev= 0.00
And here is my /proc/bus/usb/drivers file:
48- 63: usbscanner
hub
usbdevfs
Anyone have any ideas?
Ken
Ken & Penny Plumbly
email: [EMAIL PROTECTED]
The eternal God is your refuge, and underneath
are the everlasting arms. Deuteronomy 33:27
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
