Hi, Martin Tested-by: Sean Wang <[email protected]>
I've tested the series with U2 storage and U3 ethernet devices on both boards MT7623 BPI-R2 and MT7622 RFB1 using xhci-mtk driver, they are still working well. Below is related logs for test devices probing ---- # [ 42.590356] usb 2-1: new SuperSpeed USB device number 2 using xhci-mtk [ 42.719883] usb-storage 2-1:1.0: USB Mass Storage device detected [ 42.726339] scsi host2: usb-storage 2-1:1.0 [ 43.815572] scsi 2:0:0:0: Direct-Access Kingston DataTraveler 3.0 PMAP PQ: 0 ANSI: 6 [ 44.792938] sd 2:0:0:0: [sda] 30728832 512-byte logical blocks: (15.7 GB/14.7 GiB) [ 44.800658] sd 2:0:0:0: [sda] Write Protect is off [ 44.805582] sd 2:0:0:0: [sda] No Caching mode page found [ 44.810888] sd 2:0:0:0: [sda] Assuming drive cache: write through ---- # [ 134.270617] usb 2-1: new SuperSpeed USB device number 3 using xhci-mtk [ 134.664163] ax88179_178a 2-1:1.0 eth1: register 'ax88179_178a' at usb-1a1c0000.usb-1, ASIX AX88179 USB 3.0 Gigabit Ethernet, 00:11:6b:68:4c:9e On Sat, 2018-03-03 at 22:43 +0100, Martin Blumenstingl wrote: > The new PHY wrapper is now wired up in the core HCD code. This means > that PHYs are now controlled (initialized, enabled, disabled, exited) > without requiring any host-driver specific code. > Remove the custom USB PHY handling from the xhci-mtk driver as the core > HCD code now handles this. > > Signed-off-by: Martin Blumenstingl <[email protected]> > --- > drivers/usb/host/xhci-mtk.c | 98 > +-------------------------------------------- > 1 file changed, 2 insertions(+), 96 deletions(-) > > diff --git a/drivers/usb/host/xhci-mtk.c b/drivers/usb/host/xhci-mtk.c > index b0ab4d5e2751..7334da9e9779 100644 > --- a/drivers/usb/host/xhci-mtk.c > +++ b/drivers/usb/host/xhci-mtk.c > @@ -14,7 +14,6 @@ > #include <linux/mfd/syscon.h> > #include <linux/module.h> > #include <linux/of.h> > -#include <linux/phy/phy.h> > #include <linux/platform_device.h> > #include <linux/pm_runtime.h> > #include <linux/regmap.h> > @@ -352,62 +351,6 @@ static const struct xhci_driver_overrides > xhci_mtk_overrides __initconst = { > > static struct hc_driver __read_mostly xhci_mtk_hc_driver; > > -static int xhci_mtk_phy_init(struct xhci_hcd_mtk *mtk) > -{ > - int i; > - int ret; > - > - for (i = 0; i < mtk->num_phys; i++) { > - ret = phy_init(mtk->phys[i]); > - if (ret) > - goto exit_phy; > - } > - return 0; > - > -exit_phy: > - for (; i > 0; i--) > - phy_exit(mtk->phys[i - 1]); > - > - return ret; > -} > - > -static int xhci_mtk_phy_exit(struct xhci_hcd_mtk *mtk) > -{ > - int i; > - > - for (i = 0; i < mtk->num_phys; i++) > - phy_exit(mtk->phys[i]); > - > - return 0; > -} > - > -static int xhci_mtk_phy_power_on(struct xhci_hcd_mtk *mtk) > -{ > - int i; > - int ret; > - > - for (i = 0; i < mtk->num_phys; i++) { > - ret = phy_power_on(mtk->phys[i]); > - if (ret) > - goto power_off_phy; > - } > - return 0; > - > -power_off_phy: > - for (; i > 0; i--) > - phy_power_off(mtk->phys[i - 1]); > - > - return ret; > -} > - > -static void xhci_mtk_phy_power_off(struct xhci_hcd_mtk *mtk) > -{ > - unsigned int i; > - > - for (i = 0; i < mtk->num_phys; i++) > - phy_power_off(mtk->phys[i]); > -} > - > static int xhci_mtk_ldos_enable(struct xhci_hcd_mtk *mtk) > { > int ret; > @@ -488,8 +431,6 @@ static int xhci_mtk_probe(struct platform_device *pdev) > struct xhci_hcd *xhci; > struct resource *res; > struct usb_hcd *hcd; > - struct phy *phy; > - int phy_num; > int ret = -ENODEV; > int irq; > > @@ -529,16 +470,6 @@ static int xhci_mtk_probe(struct platform_device *pdev) > return ret; > } > > - mtk->num_phys = of_count_phandle_with_args(node, > - "phys", "#phy-cells"); > - if (mtk->num_phys > 0) { > - mtk->phys = devm_kcalloc(dev, mtk->num_phys, > - sizeof(*mtk->phys), GFP_KERNEL); > - if (!mtk->phys) > - return -ENOMEM; > - } else { > - mtk->num_phys = 0; > - } > pm_runtime_enable(dev); > pm_runtime_get_sync(dev); > device_enable_async_suspend(dev); > @@ -596,23 +527,6 @@ static int xhci_mtk_probe(struct platform_device *pdev) > mtk->has_ippc = false; > } > > - for (phy_num = 0; phy_num < mtk->num_phys; phy_num++) { > - phy = devm_of_phy_get_by_index(dev, node, phy_num); > - if (IS_ERR(phy)) { > - ret = PTR_ERR(phy); > - goto put_usb2_hcd; > - } > - mtk->phys[phy_num] = phy; > - } > - > - ret = xhci_mtk_phy_init(mtk); > - if (ret) > - goto put_usb2_hcd; > - > - ret = xhci_mtk_phy_power_on(mtk); > - if (ret) > - goto exit_phys; > - > device_init_wakeup(dev, true); > > xhci = hcd_to_xhci(hcd); > @@ -630,7 +544,7 @@ static int xhci_mtk_probe(struct platform_device *pdev) > dev_name(dev), hcd); > if (!xhci->shared_hcd) { > ret = -ENOMEM; > - goto power_off_phys; > + goto disable_device_wakeup; > } > > ret = usb_add_hcd(hcd, irq, IRQF_SHARED); > @@ -653,13 +567,9 @@ static int xhci_mtk_probe(struct platform_device *pdev) > xhci_mtk_sch_exit(mtk); > usb_put_hcd(xhci->shared_hcd); > > -power_off_phys: > - xhci_mtk_phy_power_off(mtk); > +disable_device_wakeup: > device_init_wakeup(dev, false); > > -exit_phys: > - xhci_mtk_phy_exit(mtk); > - > put_usb2_hcd: > usb_put_hcd(hcd); > > @@ -682,8 +592,6 @@ static int xhci_mtk_remove(struct platform_device *dev) > struct xhci_hcd *xhci = hcd_to_xhci(hcd); > > usb_remove_hcd(xhci->shared_hcd); > - xhci_mtk_phy_power_off(mtk); > - xhci_mtk_phy_exit(mtk); > device_init_wakeup(&dev->dev, false); > > usb_remove_hcd(hcd); > @@ -718,7 +626,6 @@ static int __maybe_unused xhci_mtk_suspend(struct device > *dev) > del_timer_sync(&xhci->shared_hcd->rh_timer); > > xhci_mtk_host_disable(mtk); > - xhci_mtk_phy_power_off(mtk); > xhci_mtk_clks_disable(mtk); > usb_wakeup_set(mtk, true); > return 0; > @@ -732,7 +639,6 @@ static int __maybe_unused xhci_mtk_resume(struct device > *dev) > > usb_wakeup_set(mtk, false); > xhci_mtk_clks_enable(mtk); > - xhci_mtk_phy_power_on(mtk); > xhci_mtk_host_enable(mtk); > > xhci_dbg(xhci, "%s: restart port polling\n", __func__); -- To unsubscribe from this list: send the line "unsubscribe linux-usb" in the body of a message to [email protected] More majordomo info at http://vger.kernel.org/majordomo-info.html
