On Thu, May 03, 2018 at 04:13:05PM +0300, Mathias Nyman wrote:
> On 03.05.2018 12:30, Esokrates wrote:
> > Hi,> Beginning with Linux 4.16 rc7 (4.16 rc6 was NOT affected), I do
> > find the following regularly in dmesg (often it does not happen during
> > boot, but after suspend to ram / resume):
> >
>
> Hi
>
> Can you try 'git bisect' to find the patch that causes the issues?
> (Adding Mika to Cc)
Could you try to revert:
13d3047c8150 ("ACPI / hotplug / PCI: Check presence of slot itself in
get_slot_status()")
and see if the problem goes away?
> > [ 216.443309] pcieport 0000:00:1c.0: AER: Corrected error received: id=00e0
> > [ 216.443951] pcieport 0000:00:1c.0: PCIe Bus Error: severity=Corrected,
> > type=Physical Layer, id=00e0(Receiver ID)
> > [ 216.444607] pcieport 0000:00:1c.0: device [8086:9d10] error
> > status/mask=00000001/00002000
> > [ 216.445300] pcieport 0000:00:1c.0: [ 0] Receiver Error (First)
> > [ 216.517886] xhci_hcd 0000:39:00.0: remove, state 4
> > [ 216.518573] usb usb4: USB disconnect, device number 1
> > [ 216.519438] xhci_hcd 0000:39:00.0: USB bus 4 deregistered
> > [ 216.520320] xhci_hcd 0000:39:00.0: xHCI host controller not responding,
> > assume dead
> > [ 216.521908] xhci_hcd 0000:39:00.0: remove, state 4
> > [ 216.522950] usb usb3: USB disconnect, device number 1
> > [ 216.523891] xhci_hcd 0000:39:00.0: Host halt failed, -19
> > [ 216.524994] xhci_hcd 0000:39:00.0: Host not accessible, reset failed.
> > [ 216.526153] xhci_hcd 0000:39:00.0: USB bus 3 deregistered
> >
> >
> > Running 4.16.0 I also observed
> >
> > [ 31.509282] ACPI: Waking up from system sleep state S3
> > [ 31.809429] ACPI: EC: interrupt unblocked
> > [ 31.828849] pci_raw_set_power_state: 62 callbacks suppressed
> > [ 31.828852] pcieport 0000:01:00.0: Refused to change power state,
> > currently in D3
> > [ 31.830422] pcieport 0000:02:01.0: Refused to change power state,
> > currently in D3
> > [ 31.830423] pcieport 0000:02:02.0: Refused to change power state,
> > currently in D3
> > [ 31.848853] pcieport 0000:02:00.0: Refused to change power state,
> > currently in D3
> > [ 31.852520] xhci_hcd 0000:39:00.0: Refused to change power state,
> > currently in D3
> > [ 31.872529] thunderbolt 0000:03:00.0: Refused to change power state,
> > currently in D3
> > [ 31.933970] thunderbolt 0000:03:00.0: control channel starting...
> > [ 31.937403] ACPI: EC: event unblocked
> > [ 31.938385] sd 2:0:0:0: [sda] Starting disk
> > [ 31.938886] ACPI: button: The lid device is not compliant to SW_LID.
> > [ 31.956574] xhci_hcd 0000:39:00.0: Refused to change power state,
> > currently in D3
> > [ 31.956624] xhci_hcd 0000:39:00.0: WARN: xHC restore state timeout
> > [ 31.956631] xhci_hcd 0000:39:00.0: PCI post-resume error -110!
> > [ 31.956656] xhci_hcd 0000:39:00.0: HC died; cleaning up
> > [ 31.956658] xhci_hcd 0000:39:00.0: HC died; cleaning up
> > [ 31.956664] dpm_run_callback(): pci_pm_resume+0x0/0xb0 returns -110
> > [ 31.956668] PM: Device 0000:39:00.0 failed to resume async: error -110
> >
> > Furthermore sometimes I also get a bunch of these errors before the errors
> > above:
> > May 03 10:58:49 debian kernel: usb 1-3: device descriptor read/64, error -71
> > May 03 10:58:49 debian kernel: usb 1-3: device descriptor read/64, error -71
> > May 03 10:58:50 debian kernel: usb 1-3: device descriptor read/64, error -71
> > May 03 10:58:50 debian kernel: usb 1-3: device descriptor read/64, error -71
> > May 03 10:58:51 debian kernel: usb 1-3: device not accepting address 2,
> > error -71
> >
> > All of this never happened before 4.16rc7. All kernels since 4.16.rc7 are
> > reproducibly affected (suspend/resume helps triggering), including
> > 4.17.0rc3.
> >
> > My hardware is a XPS 13 9360 Kabylake, lsub and lspci output are attached.
> >
> > I am not subscribed to the mailing list, so please CC me when replying to
> > the list.
> >
> > Thanks very much!
--
To unsubscribe from this list: send the line "unsubscribe linux-usb" in
the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
