dwc2_readl_rep/dwc2_writel_rep functions using readl/writel in a
loop.
Signed-off-by: Gevorg Sahakyan <sahak...@synopsys.com>
---
drivers/usb/dwc2/core.h | 61 ++++++++++++++++++-----------------------------
drivers/usb/dwc2/gadget.c | 6 ++---
2 files changed, 26 insertions(+), 41 deletions(-)
diff --git a/drivers/usb/dwc2/core.h b/drivers/usb/dwc2/core.h
index c24cf9b6140d..a32ff26386c2 100644
--- a/drivers/usb/dwc2/core.h
+++ b/drivers/usb/dwc2/core.h
@@ -1040,60 +1040,45 @@ struct dwc2_hsotg {
#endif /* CONFIG_USB_DWC2_PERIPHERAL || CONFIG_USB_DWC2_DUAL_ROLE */
};
-#ifdef CONFIG_MIPS
-/*
- * There are some MIPS machines that can run in either big-endian
- * or little-endian mode and that use the dwc2 register without
- * a byteswap in both ways.
- * Unlike other architectures, MIPS apparently does not require a
- * barrier before the __raw_writel() to synchronize with DMA but does
- * require the barrier after the __raw_writel() to serialize a set of
- * writes. This set of operations was added specifically for MIPS and
- * should only be used there.
- */
+/* Normal architectures just use readl/write */
static inline u32 dwc2_readl(struct dwc2_hsotg *hsotg, u32 offset)
{
- u32 value = __raw_readl(hsotg->regs + offset);
-
- /* In order to preserve endianness __raw_* operation is used. Therefore
- * a barrier is needed to ensure IO access is not re-ordered across
- * reads or writes
- */
- mb();
- return value;
+ return readl(hsotg->regs + offset);
}
static inline void dwc2_writel(struct dwc2_hsotg *hsotg, u32 value, u32 offset)
{
- __raw_writel(value, hsotg->regs + offset);
-
- /*
- * In order to preserve endianness __raw_* operation is used. Therefore
- * a barrier is needed to ensure IO access is not re-ordered across
- * reads or writes
- */
- mb();
+ writel(value, hsotg->regs + offset);
+
#ifdef DWC2_LOG_WRITES
- pr_info("INFO:: wrote %08x to %p\n", value, hsotg->regs + offset);
+ pr_info("info:: wrote %08x to %p\n", value, hsotg->regs + offset);
#endif
}
-#else
-/* Normal architectures just use readl/write */
-static inline u32 dwc2_readl(struct dwc2_hsotg *hsotg, u32 offset)
+static inline void dwc2_readl_rep(struct dwc2_hsotg *hsotg, u32 offset,
+ void *buffer, unsigned int count)
{
- return readl(hsotg->regs + offset);
+ if (count) {
+ u32 *buf = buffer;
+
+ do {
+ u32 x = dwc2_readl(hsotg, offset);
+ *buf++ = x;
+ } while (--count);
+ }
}
-static inline void dwc2_writel(struct dwc2_hsotg *hsotg, u32 value, u32 offset)
+static inline void dwc2_writel_rep(struct dwc2_hsotg *hsotg, u32 offset,
+ const void *buffer, unsigned int count)
{
- writel(value, hsotg->regs + offset);
+ if (count) {
+ const u32 *buf = buffer;
-#ifdef DWC2_LOG_WRITES
- pr_info("info:: wrote %08x to %p\n", value, hsotg->regs + offset);
-#endif
+ do {
+ dwc2_writel(hsotg, *buf++, offset);
+ } while (--count);
+ }
}
-#endif
/* Reasons for halting a host channel */
enum dwc2_halt_status {
diff --git a/drivers/usb/dwc2/gadget.c b/drivers/usb/dwc2/gadget.c
index 3cde8a01baa6..651db5cfc644 100644
--- a/drivers/usb/dwc2/gadget.c
+++ b/drivers/usb/dwc2/gadget.c
@@ -593,7 +593,7 @@ static int dwc2_hsotg_write_fifo(struct dwc2_hsotg *hsotg,
to_write = DIV_ROUND_UP(to_write, 4);
data = hs_req->req.buf + buf_pos;
- iowrite32_rep(hsotg->regs + EPFIFO(hs_ep->index), data, to_write);
+ dwc2_writel_rep(hsotg, EPFIFO(hs_ep->index), data, to_write);
return (to_write >= can_write) ? -ENOSPC : 0;
}
@@ -2174,8 +2174,8 @@ static void dwc2_hsotg_rx_data(struct dwc2_hsotg *hsotg,
int ep_idx, int size)
* note, we might over-write the buffer end by 3 bytes depending on
* alignment of the data.
*/
- ioread32_rep(hsotg->regs + EPFIFO(ep_idx),
- hs_req->req.buf + read_ptr, to_read);
+ dwc2_readl_rep(hsotg, EPFIFO(ep_idx),
+ hs_req->req.buf + read_ptr, to_read);
}
/**
--
2.11.0
--
To unsubscribe from this list: send the line "unsubscribe linux-usb" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
