Hi Geert,
On Wed, May 15, 2019, Geert Uytterhoeven wrote:
> > +/* USB-0 as Host */
> > +/* NOTE: Requires JP3 to be fitted */
>
> This not applies to the dr_mode property below, right?
> So perhaps it should be moved there...
>
> > +&usb2_phy0 {
> > + pinctrl-names = "default";
> > + pinctrl-0 = <&usb0_pins>;
> > + dr_mode = "host";
>
> ... like:
>
> dr_mode = "host"; /* Requires JP3 to be fitted */
OK, if you think it makes more sense there.
> Does resistor R78 need to be mounted, too?
By default, R78 and R79 are not populated on these boards, and both Host
and Function work fine without board modification, so I would say
populating R78 is not a requirement as far as I can tell.
Chris
