On Fri, Aug 02, 2019 at 05:33:35PM +0900, Yoshihiro Shimoda wrote:
> When a USB device is connected to the host controller and
> the system enters suspend, the following error happens
> in xhci_suspend():
>
> xhci-hcd ee000000.usb: WARN: xHC CMD_RUN timeout
>
> Since the firmware/internal CPU control the USBSTS.STS_HALT
> and the process speed is down when the roothub port enters U3,
> long delay for the handshake of STS_HALT is neeed in xhci_suspend().
> So, this patch adds to set the XHCI_SLOW_SUSPEND.
>
> Fixes: 435cc1138ec9 ("usb: host: xhci-plat: set resume_quirk() for R-Car
> controllers")
> Cc: <[email protected]> # v4.12+
> Signed-off-by: Yoshihiro Shimoda <[email protected]>
Reviewed-by: Simon Horman <[email protected]>
> ---
> drivers/usb/host/xhci-rcar.c | 9 +++++++--
> 1 file changed, 7 insertions(+), 2 deletions(-)
>
> diff --git a/drivers/usb/host/xhci-rcar.c b/drivers/usb/host/xhci-rcar.c
> index 671bce1..8616c52 100644
> --- a/drivers/usb/host/xhci-rcar.c
> +++ b/drivers/usb/host/xhci-rcar.c
> @@ -238,10 +238,15 @@ int xhci_rcar_init_quirk(struct usb_hcd *hcd)
> * pointers. So, this driver clears the AC64 bit of xhci->hcc_params
> * to call dma_set_coherent_mask(dev, DMA_BIT_MASK(32)) in
> * xhci_gen_setup().
> + *
> + * And, since the firmware/internal CPU control the USBSTS.STS_HALT
> + * and the process speed is down when the roothub port enters U3,
> + * long delay for the handshake of STS_HALT is neeed in xhci_suspend().
> */
> if (xhci_rcar_is_gen2(hcd->self.controller) ||
> - xhci_rcar_is_gen3(hcd->self.controller))
> - xhci->quirks |= XHCI_NO_64BIT_SUPPORT;
> + xhci_rcar_is_gen3(hcd->self.controller)) {
> + xhci->quirks |= XHCI_NO_64BIT_SUPPORT | XHCI_SLOW_SUSPEND;
> + }
nit: As there is still only one line guarded by the conditional I don't
think that { } need to be added.
>
> if (!xhci_rcar_wait_for_pll_active(hcd))
> return -ETIMEDOUT;
> --
> 2.7.4
>
