On Wed, 2 Dec 2015, Al Cooper wrote: > Currently usb_port_resume waits for up to 2 seconds for CONNECT > status for SS devices only. This change will do the same thing for > non-SS devices even though the reason is a little different. This > will fix an issue where VBUS is turned off during system wide > "suspend to ram" and some 2.0 devices take greater than the current > max of 100ms to show connected after VBUS is enabled. This is most > commonly seen on hard drive based devices and USB3.0 devices plugged > into a 2.0 only port. > > Signed-off-by: Al Cooper <[email protected]> > --- > drivers/usb/core/hub.c | 6 +++--- > 1 file changed, 3 insertions(+), 3 deletions(-) > > diff --git a/drivers/usb/core/hub.c b/drivers/usb/core/hub.c > index bdeadc1..d32824b 100644 > --- a/drivers/usb/core/hub.c > +++ b/drivers/usb/core/hub.c > @@ -3322,7 +3322,7 @@ static int finish_port_resume(struct usb_device *udev) > * This routine should only be called when persist is enabled for a SS > * device. > */ > -static int wait_for_ss_port_enable(struct usb_device *udev, > +static int wait_for_connected(struct usb_device *udev, > struct usb_hub *hub, int *port1, > u16 *portchange, u16 *portstatus) > {
Please update the comments at the head of this routine to match. Alan Stern -- To unsubscribe from this list: send the line "unsubscribe linux-usb" in the body of a message to [email protected] More majordomo info at http://vger.kernel.org/majordomo-info.html
