Hi,
On a mx28 custom board with a USB hub I can get a USB stick to get
detected after applying this change:
http://marc.info/?l=linux-usb&m=145079935324339&w=2
Things work fine if I boot without the USB stick connected. Then I can
insert/remove the USB device and it always gets detected.
However, if I boot with the USB stick connected I get:
[ 2.968513] hub 1-1:1.0: USB hub found
[ 2.973096] hub 1-1:1.0: 2 ports detected
[ 3.479731] usb 1-1: USB disconnect, device number 2
[ 3.525403] usb usb1-port1: cannot reset (err = -32)
[ 3.530828] usb usb1-port1: cannot reset (err = -32)
[ 3.536089] usb usb1-port1: cannot reset (err = -32)
[ 3.541600] usb usb1-port1: cannot reset (err = -32)
[ 3.546857] usb usb1-port1: cannot reset (err = -32)
[ 3.551982] usb usb1-port1: Cannot enable. Maybe the USB cable is bad?
[ 3.560302] usb usb1-port1: cannot reset (err = -32)
[ 3.565566] usb usb1-port1: cannot reset (err = -32)
[ 3.571011] usb usb1-port1: cannot reset (err = -32)
[ 3.576266] usb usb1-port1: cannot reset (err = -32)
[ 3.581769] usb usb1-port1: cannot reset (err = -32)
[ 3.586780] usb usb1-port1: Cannot enable. Maybe the USB cable is bad?
[ 3.594138] usb usb1-port1: cannot reset (err = -32)
[ 3.599615] usb usb1-port1: cannot reset (err = -32)
[ 3.604871] usb usb1-port1: cannot reset (err = -32)
[ 3.610244] usb usb1-port1: cannot reset (err = -32)
[ 3.615499] usb usb1-port1: cannot reset (err = -32)
[ 3.620649] usb usb1-port1: Cannot enable. Maybe the USB cable is bad?
[ 3.627989] usb usb1-port1: cannot reset (err = -32)
[ 3.633370] usb usb1-port1: cannot reset (err = -32)
[ 3.638617] usb usb1-port1: cannot reset (err = -32)
[ 3.644171] usb usb1-port1: cannot reset (err = -32)
[ 3.649546] usb usb1-port1: cannot reset (err = -32)
[ 3.654557] usb usb1-port1: Cannot enable. Maybe the USB cable is bad?
[ 3.661650] usb usb1-port1: unable to enumerate USB device
And the only way to get the USB port working again is to remove the
USB stick and reboot the board.
Commit d0ee68b59e6aa33221 ("usb: phy: mxs: Add VF610 USB PHY support")
shows the same error messages in the commit log, but trying the same
approach of adding the MXS_PHY_NEED_IP_FIX flag does not help on mx28.
Any suggestions?
Thanks,
Fabio Estevam
--
To unsubscribe from this list: send the line "unsubscribe linux-usb" in
the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
