On 4/7/2016 3:32 PM, Purna Chandra Mandal wrote:

Document devicetree binding for the USB controller
and USB Phy found on Microchip PIC32 class devices.

Signed-off-by: Purna Chandra Mandal <[email protected]>

---

Changes in v2: None

  .../bindings/usb/microchip,pic32-musb.txt          | 67 ++++++++++++++++++++++
  1 file changed, 67 insertions(+)
  create mode 100644 
Documentation/devicetree/bindings/usb/microchip,pic32-musb.txt

diff --git a/Documentation/devicetree/bindings/usb/microchip,pic32-musb.txt 
b/Documentation/devicetree/bindings/usb/microchip,pic32-musb.txt
new file mode 100644
index 0000000..e1cec9d
--- /dev/null
+++ b/Documentation/devicetree/bindings/usb/microchip,pic32-musb.txt
@@ -0,0 +1,67 @@
+Microchip PIC32 MUSB DRC/OTG controller
+-------------------------------------------
+
+Required properties:
+ - compatible       : should be "microchip,pic32mzda-usb".
+ - reg              : offset and length of "MUSB Core Registers" and
+                      "USB Clock & Reset Registers".
+ - reg-names        : should be "mc", and "usbcr" in order
+ - clocks           : clock specifier for the musb controller clock
+ - clock-names      : should be "usb_clk"
+ - interrupts       : interrupt number for MUSB Core General interrupt
+                      and DMA interrupt
+ - interrupt-names  : must be "mc" and "dma" in order.
+ - phys             : phy specifier for the otg phy.
+ - dr_mode          : should be one of "host", "peripheral" or "otg".
+ - mentor,multipoint: Should be "1" indicating the musb controller supports
+                      multipoint. This is MUSB configuration-specific setting.
+ - mentor,num-eps   : Specifies the number of endpoints. This is also a
+                      MUSB configuration-specific setting. Should be set to 
"8".
+ - mentor,ram-bits  : Specifies the ram address size. Should be set to "11".
+ - mentor,power     : Should be "500". This signifies the controller can supply
+                      up to 500mA when operating in host mode.
+ - phys             : phandle of the USB phy.

   Just noticed that "phys" is described twice. :-/

MBR, Sergei

--
To unsubscribe from this list: send the line "unsubscribe linux-usb" in
the body of a message to [email protected]
More majordomo info at  http://vger.kernel.org/majordomo-info.html

Reply via email to