On Wed, Jul 19, 2017 at 01:23:27PM +0200, Anatolij Gustschin wrote: > On Wed, 19 Jul 2017 11:03:11 +0200 > Johan Hovold [email protected] wrote: > > >On Thu, Jul 13, 2017 at 06:25:25PM +0200, Anatolij Gustschin wrote: > >> On FT232H the interface mode can be configured in the EEPROM, > >> and the async UART mode is configured by default. The chip is > >> also in async UART mode if no EEPROM is connected. > >> > >> Check the EEPROM configuration and do not bind as serial device > >> when different interface mode is programmed in the EEPROM. > > > >Thanks for the patch. As you may have inferred from my reply to your MFD > >series, this won't be needed for a while still however. > > > >Also note that some people already use asynchronous FIFO mode using this > >driver (also mentioned in the datasheets as an option) so only binding > >in UART mode would be too restrictive. > > You probably mean asynchronous bitbang mode, not asynchronous FIFO > mode?
No, I really meant asynchronous FIFO mode. And as mentioned in the data sheets that can be used with the normal serial (VCP) drivers on both Linux and that other OS. > This bitbang mode can always be set by sending a chip command > (mentioned as software configured in the datasheets) > Could you please point to code in this driver used for non-UART modes? > I don't see such code by a quick glance. There are some quirks for > various JTAG adapters to skip binding as serial port (the ftdi_sio > driver is not used in JTAG operation modes then). Or do people use > usual serial interface to send data in bitbang modes? Exactly. > Async and sync FIFO (FT245) modes however can only be configured via > EEPROM settings, at least for FT232H. Right. Thanks, Johan -- To unsubscribe from this list: send the line "unsubscribe linux-usb" in the body of a message to [email protected] More majordomo info at http://vger.kernel.org/majordomo-info.html
