From the command line, use ifconfig. eth0 has the address 192.168.0.2
ifconfig
eth0 Link encap:Ethernet HWaddr 00:50:8B:D7:74:92
inet addr:192.168.0.2 Bcast:192.168.0.255 Mask:255.255.255.0
inet6 addr: fe80::250:8bff:fed7:7492/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:587502 errors:0 dropped:0 overruns:0 frame:0
TX packets:513349 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:376122678 (358.6 MiB) TX bytes:331684284 (316.3 MiB)
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:139005 errors:0 dropped:0 overruns:0 frame:0
TX packets:139005 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:136810938 (130.4 MiB) TX bytes:136810938 (130.4 MiB)
Cheers,
Carl.
On 05/03/07, Gabriella Turek <[EMAIL PROTECTED]> wrote:
Can't remember where to look for it, obviously not in /etc/hosts...
gaby
--
***************************************************************
** Gabriella Turek [EMAIL PROTECTED] **
** National Institute of Water & Atmospheric Research (NIWA) **
** PO Box 8602 Christchurch New Zealand +64-3-348-8987x3724 **
***************************************************************
