On 12/17/02 06:53, Richard R. Sivernell wrote:
I don't see what isapnp.conf has to do with configuring a PCMCIA card? At any rate, go here http://pcmcia-cs.sourceforge.net/ftp/SUPPORTED.CARDS and verify exactly which module(s) you need to support that card, since you failed to provide the model# for the card. According to that page _NO_ xircom cards need or use serial_cs for anything. Also, please post the relevant output from dmesg where your'e seeing an error.ListI have been trying to get a xircom combo ether card to load and go to the net. I have read & reread many times the howto. This laptop had peanut linux running beatiful with this card. Now I have eWorkstation 3.1.1 on the hard drive and cannot set up cad. 1. Dmesg says resources are busy 2. cardctl ident knows the proper card 3. modprobe of xirc2ps_cs & serial_cs 4. lsmod shows all loaded with no use. 5. ifconfig fails to create eth0 Does any one have a isapnp.conf that has the pcmcia ether setup. or tell me how to fix my problem. You also can contact me offline.
I've also heard quite a few reports of PCMCIA being badly broken in Caldera releases (and apparently the recent SCO linux release), so that could be part of the problem as well.
I own a Xircom NIC/modem combo card, and it works flawlessly under Redhat.
--
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
L. Friedman [EMAIL PROTECTED]
Linux Step-by-step & TyGeMo: http://netllama.ipfox.com
8:45pm up 3 days, 3:56, 1 user, load average: 0.13, 0.27, 0.35
_______________________________________________
Linux-users mailing list
[EMAIL PROTECTED]
Unsubscribe/Suspend/Etc -> http://www.linux-sxs.org/mailman/listinfo/linux-users
