Hi, Tom:
I tried the variation of the mount command you suggested (below) and
that produced the same output as if I had typed "mount --help."
I surmise the key to this problem is knowing what file system type
YaST2 used to write to the floppy disk during the installation of SuSE
7.2 This is a boot disk produced during the installation, and I think
it also has the LILO configuration on it. That's what I want to look
at.
I boot SuSE 7.2 from a floppy, not from LILO on the hard drive. I want
to set up LILO on the hard drive, and I want to use what's on the boot
floppy for an example.
Thanks for your suggestion.
Regards,
Glenn
On Monday 09 July 2001 12:11 pm, you wrote:
> Glenn Williams wrote:
> > Hi, Michael:
> >
> > No, the mount point is actually /media/floppy (see the fstab entry
> > below in my original message).
[snip]
>
> You could try the full, long way of mounting it: mount -t ext2
> /dev/fd0 /media/floppy and see if that gives you any love.
>
> --Tom Wilson
> _______________________________________________
> http://linux.nf -- [EMAIL PROTECTED]
> Archives, Subscribe, Unsubscribe, Digest, Etc
> ->http://linux.nf/mailman/listinfo/linux-users
--
Glenn Williams - [EMAIL PROTECTED]
Registered Linux User # 135678
Powered by SuSE 7.2
_______________________________________________
http://linux.nf -- [EMAIL PROTECTED]
Archives, Subscribe, Unsubscribe, Digest, Etc
->http://linux.nf/mailman/listinfo/linux-users
