Hi, Laurent Pinchart a écrit : > Hi, > >> Hello, >> I tried to install a lifecam NX-6000 on my gentoo. >> I have tried with the ebuild and with the svn. In both case my problem >> is the same. >> When I modprobe uvcvideo I get this messages in dmesg: >> >> >> uvcvideo: Found UVC 1.00 device Microsoft� LifeCam NX-6000 (045e:00f8) >> uvcvideo: Failed to query (135) UVC control 1 (unit 0) : -32 (exp. 26). >> uvcvideo: Failed to initialize the device (-5). >> usbcore: registered new interface driver uvcvideo >> USB Video Class driver (v0.1.0) >> > [snip] >> Do you have any idea of what I can try to make this tiny webcam working? > > Yep, try to update your sources from SVN to get the patch that has been > committed a few minutes ago :-) > >> Thanks a lot for your help and for uvccideo > > You're welcome. Please tell me if the latest driver version works with the > NX-6000. > > Cheers, > > Laurent Pinchart Thanks for your help. With the last version if I connect my webcam after a modprobe /dev/video0 is created and luvcview grab the video. So it's a very good point :p
But (yes there is a but) I tried to use ekiga. My webcam is well found by this software but when I tried to activate it the "microsoft" on the webcam blink a little and then shutdown. Ekiga display a message saying that there is an error when opening the device. dmesg display this messages: uvcvideo: uvc_v4l2_open uvcvideo: uvc_v4l2_ioctl v4l2 ioctl VIDIOC_QUERYCAP, dir=r- (0x80685600) uvcvideo: uvc_v4l2_release uvcvideo: uvc_v4l2_open uvcvideo: uvc_v4l2_ioctl v4l2 ioctl VIDIOC_QUERYCAP, dir=r- (0x80685600) uvcvideo: uvc_v4l2_release So I think that now this is a ekiga but if you have a new bright idea i'm ready to test it ;) _______________________________________________ Linux-uvc-devel mailing list Linux-uvc-devel@lists.berlios.de https://lists.berlios.de/mailman/listinfo/linux-uvc-devel
