Hi,
Some days ago I' ve tested FinePix E550 camera on an ARM based system.
As reported in previous mailing list,using uvccapture, I got snap.jpg.
Now, I can't get more any image. The steps made are:
1) install the driver uvcvideo.
dmesg say:
usbcore: registered new driver uvcvideo
USB Video Class driver (v0.1.0)
2) Link the cam to the system:
dmesg say:
usb 2-2: new full speed USB device using isp116x-hcd and address 2
scsi1 : SCSI emulation for USB Mass Storage devices
usb-storage: device found at 2
usb-storage: waiting for device to settle before scanning
Vendor: FUJIFILM Model: USB-DRIVEUNIT Rev: 1.00
Type: Direct-Access ANSI SCSI revision: 00
SCSI device sdb: 32000 512-byte hdwr sectors (16 MB)
sdb: Write Protect is off
sdb: Mode Sense: 07 00 00 00
sdb: assuming drive cache: write through
SCSI device sdb: 32000 512-byte hdwr sectors (16 MB)
sdb: Write Protect is off
sdb: Mode Sense: 07 00 00 00
sdb: assuming drive cache: write through
sdb: sdb1
Attached scsi removable disk sdb at scsi1, channel 0, id 0, lun 0
Attached scsi generic sg1 at scsi1, channel 0, id 0, lun 0, type 0
usb-storage: device scan complete
3) Running the uvccapture :
./uvccapture -v
Using videodevice: /dev/video0
Saving images to: snap.jpg
Image size: 320x240
Taking snapshot every 0 seconds
Taking images using mmap
Chiamo Init_videoIn
ERROR opening V4L interface
: No such device
The /dev/video0 exist. So, what is the problem?
No new messase is present in dmesg output.
Thank you for any suggestions.
Best regards,
Claudio Montemaggiore
_______________________________________________
Linux-uvc-devel mailing list
[email protected]
https://lists.berlios.de/mailman/listinfo/linux-uvc-devel
