Hi Laurent, Unfortunately it did not help. Noticed a strange behavior. In the light table lamp White Balance temperature varies fps at 1 frame. fps = 6-7. If, WBT = 0 bring a sheet of white paper into the frame. FPS rises to 14.5. Removing paper, FPS remains the same(14.5). Next, if you close the lens by hand and wait for 1-2 seconds, open the lens, the FPS again fall to 6 frames and after some time (15 seconds) again rises to 14.5 frames. It was also observed decrease in fps when moving in the frame. A similar behavior of the camera at WBT = 1. One gets the feeling that the WBT only affects the color. Auto-exposure not supported by the camera?
When I run guvcview Console output: fps is set to 1/30 Could not grab image (select timeout): Resource temporarily unavailable Is this normal? 2010/10/18 Laurent Pinchart <laurent.pinch...@ideasonboard.com> > Hi Igor, > > > How to add support exposure and auto white balance? > > Auto white balance is supported as reported by your camera: > > > 9963788: White Balance Temperature, Auto: 1 > > Turning auto-exposure off isn't supported by the camera, so there's little > the > driver can do. > > > PS: You were right, the talking about it earlier. > -- Best regards, Igor Demyanov
_______________________________________________ Linux-uvc-devel mailing list Linux-uvc-devel@lists.berlios.de https://lists.berlios.de/mailman/listinfo/linux-uvc-devel
