> -----Original Message-----
> From: Johannes Berg [mailto:[email protected]]
> Sent: Friday, February 13, 2015 11:37 PM
> To: Avinash Patil
> Cc: [email protected]; Amitkumar Karwar; Cathy Luo; Xinming Hu;
> Li Long
> Subject: Re: [PATCH 1/3] mwifiex: add cfg80211 set_default_mgmt_key handler
>
> On Thu, 2015-02-12 at 23:45 +0530, Avinash Patil wrote:
> > From: Xinming Hu <[email protected]>
> >
> > It is observed that hostapd failed to setup with management frame
> > protection mode enabled when using mwifiex.
> >
> > This is because hostapd will try to install IGTK using
> > cfg80211 set_default_mgmt_key handler.
> >
> > we have already support IGTK install in set_key handler, so just work
> > around this issue by add an empty cfg80211_set_default_mgmt_key handler.
>
> I believe that this is incorrect since the key should only be installed for TX
> after this handler, not in the set_key handler. This should make a difference
> in the case of rekeying? Perhaps hostapd doesn't actually program the key
> until rekeying with all stations finishes though.
>
> johannes
Thanks for review comments, Johannes.
We will implement default_mgmt handler in a way you have suggested and send v2.
Regards,
Avinash.
N�����r��y����b�X��ǧv�^�){.n�+����{��*ޕ�,�{ay� ʇڙ�,j��f���h���z� �w���
���j:+v���w�j�m��������zZ+�����ݢj"��!�i
