Rajkumar Manoharan <[email protected]> writes: > commit 166de3f1895d ("ath10k: remove supported chain mask") had revealed > an issue on monitor mode. Configuring NSS upon monitor interface > creation is causing target assert in all qca9888x and qca6174 firmware. > Firmware assert issue can be reproduced by below sequence even after > reverting commit 166de3f1895d ("ath10k: remove supported chain mask"). > > ip link set wlan0 down > iw wlan0 set type monitor > iw phy0 set antenna 7 > ip link set wlan0 up > > This issue is originally reported on qca9888 with 10.1 firmware. > > Fixes: 5572a95b4b ("ath10k: apply chainmask settings to vdev on creation") > Reported-by: Janusz Dziedzic <[email protected]> > Signed-off-by: Rajkumar Manoharan <[email protected]>
Applied, thanks for fixing this. I also CCed stable. But I'm not actually sure if the "Fixes" lines implies "Cc stable"? I think I saw one patch going into stable like that so I have been wondering how this works. Does anyone know? -- Kalle Valo-- To unsubscribe from this list: send the line "unsubscribe linux-wireless" in the body of a message to [email protected] More majordomo info at http://vger.kernel.org/majordomo-info.html
