> -----Original Message----- > From: Kalle Valo [mailto:kv...@codeaurora.org] > Sent: Thursday, April 07, 2016 3:25 PM > To: Eyal Reizer > Cc: linux-wireless@vger.kernel.org; net...@vger.kernel.org; linux- > ker...@vger.kernel.org; Reizer, Eyal; devicet...@vger.kernel.org > Subject: Re: [PATCH] wlcore: spi: add wl18xx support > > Eyal Reizer <eyalrei...@gmail.com> writes: > > > Add support for using with both wl12xx and wl18xx. > > > > - all wilink family needs special init command for entering wspi mode. > > extra clock cycles should be sent after the spi init command while the > > cs pin is high. > > - switch to controling the cs pin from the spi driver for achieveing the > > above. > > - the selected cs gpio is read from the spi device-tree node using the > > cs-gpios field and setup as a gpio. > > - See the example below for specifying the cs gpio using the cs-gpios > > entry > > > > &spi0 { > > status = "okay"; > > pinctrl-names = "default"; > > pinctrl-0 = <&spi0_pins>; > > cs-gpios = <&gpio0 5 0>; > > #address-cells = <1>; > > #size-cells = <0>; > > wlcore: wlcore@0 { > > compatible = "ti,wl1835"; > > vwlan-supply = <&wlan_en_reg>; > > spi-max-frequency = <48000000>; > > reg = <0>; /* chip select 0 on spi0, ie spi0.0 */ > > interrupt-parent = <&gpio0>; > > interrupts = <27 IRQ_TYPE_EDGE_RISING>; > > }; > > }; > > > > Signed-off-by: Eyal Reizer <ey...@ti.com> > > [...] > > > static const struct of_device_id wlcore_spi_of_match_table[] = { > > - { .compatible = "ti,wl1271" }, > > + { .compatible = "ti,wl1271", .data = &wl12xx_data}, > > + { .compatible = "ti,wl1273", .data = &wl12xx_data}, > > + { .compatible = "ti,wl1281", .data = &wl12xx_data}, > > + { .compatible = "ti,wl1283", .data = &wl12xx_data}, > > + { .compatible = "ti,wl1801", .data = &wl18xx_data}, > > + { .compatible = "ti,wl1805", .data = &wl18xx_data}, > > + { .compatible = "ti,wl1807", .data = &wl18xx_data}, > > + { .compatible = "ti,wl1831", .data = &wl18xx_data}, > > + { .compatible = "ti,wl1835", .data = &wl18xx_data}, > > + { .compatible = "ti,wl1837", .data = &wl18xx_data}, > > { } > > Shouldn't you also update bindings/net/wireless/ti,wlcore,spi.txt? Now it only > mentions about ti,wl1271 and not anything about the rest.
You are right! Will be fixed in v2 > > Adding devicetree list for further comments. > > -- > Kalle Valo Best Regards, Eyal -- To unsubscribe from this list: send the line "unsubscribe linux-wireless" in the body of a message to majord...@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html
