Barry Day <[email protected]> writes:
> The rtl8192e and rtl8723 fail to reconnect to an AP after being
> disconnected. Ths patch fixes that without affecting the rtl8192cu.
> I don't have a rtl8723 to test but it has been tested on a rtl8192eu.
> After going through the orginal realtek code for the rtl8723, I am
> confident the patch is applicable to both.
>
> Signed-off-by: Barry Day <[email protected]>
> ---
> rtl8xxxu_core.c | 18 ++++++++++++++----
> 1 file changed, 14 insertions(+), 4 deletions(-)
Hi Barry,
Thank you for the patch. There are a couple of items which I am not
100% sure about the order of.
> diff --git a/rtl8xxxu_core.c b/rtl8xxxu_core.c
> index 04141e5..6ac10d2 100644
> --- a/rtl8xxxu_core.c
> +++ b/rtl8xxxu_core.c
> @@ -4372,17 +4372,25 @@ void rtl8xxxu_gen1_report_connect(struct
> rtl8xxxu_priv *priv,
> void rtl8xxxu_gen2_report_connect(struct rtl8xxxu_priv *priv,
> u8 macid, bool connect)
> {
> + u8 val8;
> struct h2c_cmd h2c;
>
> memset(&h2c, 0, sizeof(struct h2c_cmd));
>
> h2c.media_status_rpt.cmd = H2C_8723B_MEDIA_STATUS_RPT;
> - if (connect)
> + if (connect) {
> h2c.media_status_rpt.parm |= BIT(0);
> - else
> - h2c.media_status_rpt.parm &= ~BIT(0);
> + rtl8xxxu_gen2_h2c_cmd(priv, &h2c,
> + sizeof(h2c.media_status_rpt));
> + } else {
> + val8 = rtl8xxxu_read8(priv, REG_BEACON_CTRL);
> + val8 &= ~BEACON_FUNCTION_ENABLE;
> +
> + rtl8xxxu_write8(priv, REG_BEACON_CTRL, val8);
> + rtl8xxxu_write16(priv, REG_RXFLTMAP2, 0x00);
> + rtl8xxxu_write8(priv, REG_DUAL_TSF_RST, (BIT(0) | BIT(1)));
> + }
>
> - rtl8xxxu_gen2_h2c_cmd(priv, &h2c, sizeof(h2c.media_status_rpt));
> }
This only affects 8192eu and not 8192cu - we left RXFLTMAP2 out of here
on purpose for monitor mode, but you now disable it for 8192eu/8723bu.
> void rtl8xxxu_gen1_init_aggregation(struct rtl8xxxu_priv *priv)
> @@ -4515,6 +4523,8 @@ rtl8xxxu_bss_info_changed(struct ieee80211_hw *hw,
> struct ieee80211_vif *vif,
> sgi = 1;
> rcu_read_unlock();
>
> + rtl8xxxu_write16(priv, REG_RXFLTMAP2, 0xffff);
> +
> priv->fops->update_rate_mask(priv, ramask, sgi);
>
> rtl8xxxu_write8(priv, REG_BCN_MAX_ERR, 0xff);
Here you enable RXFLTMAP2 for all devices - this doesn't balance with
the above.
I am not against the aproach, but I think we need to investigate a
little further what is going on.
Cheers,
Jes
