From: Jes Sorensen <jes.soren...@redhat.com>
The 8192eu suffered from two issues when reloading the driver.
The same problems as with the 8723bu where REG_RX_WAIT_CCA bits 22 and
23 didn't get set in rtl8192e_enable_rf().
In addition it also seems prone to issues when setting REG_RF_CTRL to
0 intead of just disabling the RF_ENABLE bit. Similar to what was
causing issues with the 8188eu.
With this patch I can successfully reload the driver and reassociate
to an APi with an 8192eu dongle.
Signed-off-by: Jes Sorensen <jes.soren...@redhat.com>
---
drivers/net/wireless/realtek/rtl8xxxu/rtl8xxxu_8192e.c | 8 +++++++-
1 file changed, 7 insertions(+), 1 deletion(-)
diff --git a/drivers/net/wireless/realtek/rtl8xxxu/rtl8xxxu_8192e.c
b/drivers/net/wireless/realtek/rtl8xxxu/rtl8xxxu_8192e.c
index df54d27..a793fed 100644
--- a/drivers/net/wireless/realtek/rtl8xxxu/rtl8xxxu_8192e.c
+++ b/drivers/net/wireless/realtek/rtl8xxxu/rtl8xxxu_8192e.c
@@ -1461,7 +1461,9 @@ static int rtl8192eu_active_to_emu(struct rtl8xxxu_priv
*priv)
int count, ret = 0;
/* Turn off RF */
- rtl8xxxu_write8(priv, REG_RF_CTRL, 0);
+ val8 = rtl8xxxu_read8(priv, REG_RF_CTRL);
+ val8 &= ~RF_ENABLE;
+ rtl8xxxu_write8(priv, REG_RF_CTRL, val8);
/* Switch DPDT_SEL_P output from register 0x65[2] */
val8 = rtl8xxxu_read8(priv, REG_LEDCFG2);
@@ -1593,6 +1595,10 @@ static void rtl8192e_enable_rf(struct rtl8xxxu_priv
*priv)
u32 val32;
u8 val8;
+ val32 = rtl8xxxu_read32(priv, REG_RX_WAIT_CCA);
+ val32 |= (BIT(22) | BIT(23));
+ rtl8xxxu_write32(priv, REG_RX_WAIT_CCA, val32);
+
val8 = rtl8xxxu_read8(priv, REG_GPIO_MUXCFG);
val8 |= BIT(5);
rtl8xxxu_write8(priv, REG_GPIO_MUXCFG, val8);
--
2.7.4
