Iain Hunter <[email protected]> writes:
> Enable AP support allmulticast for MDNS. It can be enabled by bringing up
>
> the interface with ip command with the argument allmulticast on
>
> Signed-off-by: Iain Hunter <[email protected]>
The commit log looks now ok, except there's an unnecessare empty line.
But I can fix that.
> @@ -3281,6 +3281,20 @@ static void wl1271_op_configure_filter(struct
> ieee80211_hw *hw,
> if (ret < 0)
> goto out_sleep;
> }
> +
> + /*
> + * If interface in AP mode and created with allmulticast then disable
> + * the firmware filters so that all multicast packets are passed
> + * This is mandatory for MDNS based discovery protocols
> + */
> + if (wlvif->bss_type == BSS_TYPE_AP_BSS) {
> + if (*total & FIF_ALLMULTI)
> + ret = wl1271_acx_group_address_tbl(wl, wlvif,
> + false,
> + NULL, 0);
> +
> + }
> +
> }
Sorry, I missed this earlier but here you don't check ret value at all.
I think you should bail out from the look if an error happens, like
other commands in the same loop does.
--
Kalle Valo
