On Tue, 2017-02-07 at 20:23 +0100, Arend Van Spriel wrote: > On 7-2-2017 17:50, Paolo Abeni wrote: > > the skbs can be held by the driver for a long time, so we need > > to clear any state on xmit to avoid hanging other subsystems. > > The skbs are already orphaned later in cmsg code, so we just > > need to clear the nf/dst/secpath. > > Do it early, while the relevant entries are hopefully still > > hot in the cache. > > What is this about really? A bit more background about the issue > might > help understanding the need for this patch. Is this really specific > to > brcmfmac. For instance is something similar already done in mac80211?
The issue is apparently driver specific, as reported in: https://bugzilla.redhat.com/show_bug.cgi?id=1294415 This is caused by xmit skbs carrying a notrack ct entry not being freed by the device driver in a timely manner. Removing the ct module waits for such entries refcount going to zero and hangs the kernel in busy loop (for several minutes). The relevant skbs are icmp6 packets (ND if I recall correctly, they bcast packets at the mac level). The only other known device driver suffering for the issue is the infiniband ipoib driver, I send a separate patch for it. I lack the broadcom h/w, but with infiniband the bug can be reproduced with the following steps: - ensure ipv6 is enabled on the target device, and firewalld is running (e.g. the module nf_conntrack_ipv6 is loaded) - assign a static ip to the device - shut down the firewall (e.g. try to remove the module nf_conntrack) For the brcmfmac driver most probably it is necessary being disassociated from the AP before shutting down the firewall (but I can't double check). This is probably why mac80211 does not suffer this issue. The root cause for the issue could be actually a firmware issue, any better clues are more than welcome! Thank you, Paolo
