Channel active/busy time are showing incorrect
(less than previous or sometimes zero) for
successive survey dump command.
example:
Survey data from wlan0
frequency: 5180 MHz [in use]
channel active time: 54995 ms
channel busy time: 432 ms
channel receive time: 0 ms
channel transmit time: 59 ms
Survey data from wlan0
frequency: 5180 MHz [in use]
channel active time: 32592 ms
channel busy time: 254 ms
channel receive time: 0 ms
channel transmit time: 0 ms
This patch fix this issue by assigning 'wmi_bss_survey_req_type'
as 'WMI_BSS_SURVEY_REQ_TYPE_READ'.
Firmware ver 10.4-3.4-00082
Hardware QCA4019
Signed-off-by: Venkateswara Rao Naralasetty <c_vna...@qti.qualcomm.com>
---
drivers/net/wireless/ath/ath10k/mac.c | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)
diff --git a/drivers/net/wireless/ath/ath10k/mac.c
b/drivers/net/wireless/ath/ath10k/mac.c
index 9977829..87a9b55 100644
--- a/drivers/net/wireless/ath/ath10k/mac.c
+++ b/drivers/net/wireless/ath/ath10k/mac.c
@@ -6621,7 +6621,7 @@ static void ath10k_reconfig_complete(struct ieee80211_hw
*hw,
struct ieee80211_channel *channel)
{
int ret;
- enum wmi_bss_survey_req_type type = WMI_BSS_SURVEY_REQ_TYPE_READ_CLEAR;
+ enum wmi_bss_survey_req_type type = WMI_BSS_SURVEY_REQ_TYPE_READ;
lockdep_assert_held(&ar->conf_mutex);
--
1.7.9.5
