Amitkumar Karwar <[email protected]> writes:
> From: Prameela Rani Garnepudi <[email protected]>
>
> After successful loading of firmware, a CARD READY indication is
> received by host. Common device configuration parameters are sent
> to the device after this. It includes information like device
> operating mode (Wi-Fi alone or BT coex), power save related
> parameters, GPIO information etc. As device supports BT coex,
> this frame is send in COEX queue initially. Based on the operating
> mode, CARD READY indication is received from each protocol module
> in firmware i.e. WLAN, BT.
>
> Signed-off-by: Prameela Rani Garnepudi <[email protected]>
> Signed-off-by: Amitkumar Karwar <[email protected]>
[...]
> +static struct rsi_soc_gpio_vals unused_soc_gpio_bitmap = {
> + .pspi_csn_0 = USED_GPIO, //GPIO_0
> + .pspi_csn_1 = USED_GPIO, //GPIO_1
> + .host_wakeup_intr = USED_GPIO, //GPIO_2
> + .pspi_data_0 = USED_GPIO, //GPIO_3
> + .pspi_data_1 = USED_GPIO, //GPIO_4
> + .pspi_data_2 = USED_GPIO, //GPIO_5
> + .pspi_data_3 = USED_GPIO, //GPIO_6
> + .i2c_scl = USED_GPIO, //GPIO_7
> + .i2c_sda = USED_GPIO, //GPIO_8
> + .uart1_rx = UNUSED_GPIO, //GPIO_9
> + .uart1_tx = UNUSED_GPIO, //GPIO_10
> + .uart1_rts_i2s_clk = UNUSED_GPIO, //GPIO_11
> + .uart1_cts_i2s_ws = UNUSED_GPIO, //GPIO_12
> + .dbg_uart_rx_i2s_din = UNUSED_GPIO, //GPIO_13
> + .dbg_uart_tx_i2s_dout = UNUSED_GPIO, //GPIO_14
> + .lp_wakeup_boot_bypass = UNUSED_GPIO, //GPIO_15
> + .led_0 = USED_GPIO, //GPIO_16
> + .btcoex_wlan_active_ext_pa_ant_sel_A = UNUSED_GPIO, //GPIO_17
> + .btcoex_bt_priority_ext_pa_ant_sel_B = UNUSED_GPIO, //GPIO_18
> + .btcoex_bt_active_ext_pa_on_off = UNUSED_GPIO, //GPIO_19
> + .rf_reset = USED_GPIO, //GPIO_20
> + .sleep_ind_from_device = UNUSED_GPIO,
> +};
No //, please. Use instead /* */.
--
Kalle Valo
