On Fri 08 Dec 08:34 PST 2017, Loic Poulain wrote:
> Since driver does not report hardware dynamic power saving cap,
> this is up to the mac80211 to manage power saving timeout and
> state machine, using the ieee80211 config callback to report
> PS changes. This patch enables/disables PS mode according to
> the new configuration.
>
> Remove old behaviour enabling PS mode in a static way, this make
> the device unusable when power save is enabled since device is
> forced to PS regardless RX/TX traffic.
>
> Signed-off-by: Loic Poulain <loic.poul...@linaro.org>
Acked-by: Bjorn Andersson <bjorn.anders...@linaro.org>
With below nit.
> ---
> drivers/net/wireless/ath/wcn36xx/main.c | 23 ++++++++++++-----------
> 1 file changed, 12 insertions(+), 11 deletions(-)
>
> diff --git a/drivers/net/wireless/ath/wcn36xx/main.c
> b/drivers/net/wireless/ath/wcn36xx/main.c
> index f0b4d43..436b8ea 100644
> --- a/drivers/net/wireless/ath/wcn36xx/main.c
> +++ b/drivers/net/wireless/ath/wcn36xx/main.c
> @@ -384,6 +384,18 @@ static int wcn36xx_config(struct ieee80211_hw *hw, u32
> changed)
> }
> }
>
> + if (changed & IEEE80211_CONF_CHANGE_PS) {
> + list_for_each_entry(tmp, &wcn->vif_list, list) {
> + vif = wcn36xx_priv_to_vif(tmp);
> + if (hw->conf.flags & IEEE80211_CONF_PS) {
> + if (vif->bss_conf.ps) /* ps allowed ? */
> + wcn36xx_pmc_enter_bmps_state(wcn, vif);
> + } else {
> + wcn36xx_pmc_exit_bmps_state(wcn, vif);
During startup I get the error print from wcn36xx_pmc_exit_bmps_state()
that we're not in BMPS state. There's no harm in this, but the error
might concern people.
How about we in addition to this, change the wcn36xx_err() to a
wcn36xx_dbg(PMC...) ?
Regards,
Bjorn
