> mesh TTL offset in Mesh Channel Switch Parameters element depends on
> not only Secondary Channel Offset element, but also affected by
> HT Control field and Wide Bandwidth Channel Switch element.
> Hence take those values place in.
This seems wrong, the Wide Bandwidth Channel Switch element should come
*after* the Mesh Channel Switch Parameters, see Figure 9-647—Channel
Switch Announcement frame Action field format in 802.11-2016.
> + /* mgmt hdr 24 + csa action 15 without sec offset and wide bw */
> + unsigned int basic_hdrlen = 39;
CSA action really is 24 + 1 + 1 + 5 for header, action type/subtype,
CSA Element. Where do the other 8 bytes come from? Are those the mesh
channel switch parameters?
> + if (ieee80211_has_order(mgmt->frame_control))
> + basic_hdrlen += 4;
That would seem somewhat reasonable, but if it's correct here then the
parsing previously done in mesh_rx_csa_frame() is utterly wrong, it
seems?
> /* offset_ttl is based on whether the secondary channel
> * offset is available or not. Subtract 1 from the mesh TTL
> * and disable the initiator flag before forwarding.
> */
> - offset_ttl = (len < 42) ? 7 : 10;
> + offset_ttl = (len > basic_hdrlen) ? 10 : 7;
> *(pos + offset_ttl) -= 1;
> *(pos + offset_ttl + 1) &= ~WLAN_EID_CHAN_SWITCH_PARAM_INITIATOR;
>
> @@ -1323,7 +1332,7 @@ static void mesh_rx_csa_frame(struct
> ieee80211_sub_if_data *sdata,
>
> /* forward or re-broadcast the CSA frame */
> if (fwd_csa) {
> - if (mesh_fwd_csa_frame(sdata, mgmt, len) < 0)
> + if (mesh_fwd_csa_frame(sdata, mgmt, len, &elems) < 0)
> mcsa_dbg(sdata, "Failed to forward the CSA frame");
Here, for parsing &elems.
Either way, this really needs to be changed completely to just do
elems->mesh_chansw_params_ie->mesh_ttl--;
elems->mesh_chansw_params_ie->mesh_flags &= ~WLAN_EID_...;
If you then still have problems with the order field, then clearly that
needs to be taken into account *before* parsing the elements.
johannes
