On 01/26/2018 01:46 AM, [email protected] wrote:
From: Ping-Ke Shih <[email protected]>
In new design, SW_DEFINE[1:0] of tx desc are used by firmware, and the TX
report only contains SW_DEFINE[7:0]. To satisfy with all cases, driver uses
SW_DEFINE[7:2] as sequence number.
Besides, the format of tx report have been changed, so a new flag
RTL_SPEC_EXT_C2H is used to access report.
Signed-off-by: Ping-Ke Shih <[email protected]>
This change was tested on an old design (RTL8188CE). No problems were observed.
Acked-by: Larry Finger <[email protected]>
