+ Kalle (explicitly)
On 5/8/2018 9:58 AM, Ulf Hansson wrote:
On 4 May 2018 at 08:48, Sean Lanigan <s...@lano.id.au> wrote:
Add support for the BCM43364 chipset via an SDIO interface, as used in
e.g. the Murata 1FX module.
The BCM43364 uses the same firmware as the BCM43430 (which is already
included), the only difference is the omission of Bluetooth.
However, the SDIO_ID for the BCM43364 is 02D0:A9A4, giving it a MODALIAS
of sdio:c00v02D0dA9A4, which doesn't get recognised and hence doesn't
load the brcmfmac module. Adding the 'A9A4' ID in the appropriate place
triggers the brcmfmac driver to load, and then correctly use the
firmware file 'brcmfmac43430-sdio.bin'.
Signed-off-by: Sean Lanigan <s...@lano.id.au>
Acked-by: Ulf Hansson <ulf.hans...@linaro.org>
Arend, I assume you want to pick this up? If not, just tell and I can do it.
Not necessarily. I let Kalle do the leg work ;-) Given the change I do
not expect any conflict so we can go either way with a slight preference
for wl-drivers-next. Kalle?
Regards,
Arend
