Hello,
On Monday, June 11, 2018 10:21:56 PM CEST Sebastian Andrzej Siewior wrote:
> I've been locking at the USB completion handler and stumbled upon this
> driver. The code path:
> carl9170_usb_rx_irq_complete()
> -> carl9170_handle_command_response()
> -> carl9170_cmd_callback()
> spin_lock(&ar->cmd_lock);
>
> -> carl9170_update_beacon()
> spin_lock_bh(&ar->beacon_lock);
>
> -> carl9170_tx_process_status()
> -> __carl9170_tx_process_status()
> -> carl9170_get_queued_skb()
> spin_lock_bh(&queue->lock);
>
> -> carl9170_release_dev_space()
> spin_lock_bh(&ar->mem_lock);
> …
>
> I planned to make all locks use spin_lock_irqsave().
> carl9170_usb_rx_irq_complete() is called by HCD's completion handler
> which is invoked mostly in IRQ context except for EHCI/DWC2 which invoke
> the completion callback in tasklet/BH context. Currently there is a
> local_irq_save() before invoking the ->complete callback which I plan to
> remove, therefore the push-down. The _irqsave() would reflect the
> current status.
> The locks I mentioned use only the _bh() suffix in other places. I
> *think* lockdep is not complaining about this on EHCI but should
> complain on other controllers which really complete in IRQ-context.
> Could you please check if this is the case?
Oh, something else is going on here. First, please take a closer
look at the comment in carl9170_usb_rx_irq_complete(), just right
before the carl9170_handle_command_response() call [0].
| /*
| * While the carl9170 firmware does not use this EP, the
| * firmware loader in the EEPROM unfortunately does.
| * Therefore we need to be ready to handle out-of-band
| * responses and traps in case the firmware crashed and
| * the loader took over again.
| */
| carl9170_handle_command_response(ar, urb->transfer_buffer,
| urb->actual_length);
| ...
Incoming urbs/data/... on this EP are all out-of-band and will
cause the driver to issue a usb reset and this causes the driver
to unbind from the unresponsive/crashed/dead device.
as for the locking in carl9170:
carl9170_handle_command_response() main callee is the
carl9170_rx_untie_cmds() function, which gets called from the
carl9170_usb_rx_work() tasklet context. Hence the locking in
carl9170's rx path and its related functions is mostly done by
spin_lock[_bh]. (So, it should be fine in this context).
Now, the driver could be vulnerable to a malicious device
- after all, Apple only recently tried to fix the iPhone
USB holes (GrayKey) with iOS 12 and from what I know Sony's
PS4 have been pwned through usb as well -. So what could help
would be to replace the carl9170_handle_command_response() in
carl9170_usb_rx_irq_complete() with
carl9170_restart(ar, CARL9170_RR_INVALID_RSP);
This will cut out the middle man and be much safer against
such attacks. So, what do you think?
Regards,
Christian
[0]
<https://elixir.bootlin.com/linux/v4.14/source/drivers/net/wireless/ath/carl9170/usb.c#L299>
