Move wiphy interface_modes definition in mt76x2_init in order to reuse mt76_register_device routine supporting mt76x2u based chipsets since mt76x2u currently supports just sta mode
Signed-off-by: Lorenzo Bianconi <[email protected]> --- drivers/net/wireless/mediatek/mt76/mac80211.c | 8 -------- drivers/net/wireless/mediatek/mt76/mt76x2_init.c | 8 ++++++++ 2 files changed, 8 insertions(+), 8 deletions(-) diff --git a/drivers/net/wireless/mediatek/mt76/mac80211.c b/drivers/net/wireless/mediatek/mt76/mac80211.c index d62e34e7eadf..6a0b6f4403a8 100644 --- a/drivers/net/wireless/mediatek/mt76/mac80211.c +++ b/drivers/net/wireless/mediatek/mt76/mac80211.c @@ -303,14 +303,6 @@ int mt76_register_device(struct mt76_dev *dev, bool vht, SET_IEEE80211_DEV(hw, dev->dev); SET_IEEE80211_PERM_ADDR(hw, dev->macaddr); - wiphy->interface_modes = - BIT(NL80211_IFTYPE_STATION) | - BIT(NL80211_IFTYPE_AP) | -#ifdef CONFIG_MAC80211_MESH - BIT(NL80211_IFTYPE_MESH_POINT) | -#endif - BIT(NL80211_IFTYPE_ADHOC); - wiphy->features |= NL80211_FEATURE_ACTIVE_MONITOR; wiphy->available_antennas_tx = dev->antenna_mask; diff --git a/drivers/net/wireless/mediatek/mt76/mt76x2_init.c b/drivers/net/wireless/mediatek/mt76/mt76x2_init.c index c3ecc1c206bd..d3eedd9c59b7 100644 --- a/drivers/net/wireless/mediatek/mt76/mt76x2_init.c +++ b/drivers/net/wireless/mediatek/mt76/mt76x2_init.c @@ -841,6 +841,14 @@ int mt76x2_register_device(struct mt76x2_dev *dev) wiphy->reg_notifier = mt76x2_regd_notifier; + wiphy->interface_modes = + BIT(NL80211_IFTYPE_STATION) | + BIT(NL80211_IFTYPE_AP) | +#ifdef CONFIG_MAC80211_MESH + BIT(NL80211_IFTYPE_MESH_POINT) | +#endif + BIT(NL80211_IFTYPE_ADHOC); + wiphy_ext_feature_set(wiphy, NL80211_EXT_FEATURE_VHT_IBSS); mt76x2_dfs_init_detector(dev); -- 2.17.1
