On 11/14/2018 11:57 AM, Arend van Spriel wrote:
On 11/14/2018 11:54 AM, Andy Duan wrote:
From: Arend van Spriel [mailto:[email protected]] Sent:
2018年11月14日 16:40
To: Andy Duan <[email protected]>; David Miller
<[email protected]>; [email protected]
Cc: [email protected]
Subject: Re: [PATCH] brcmfmac: Use standard SKB list accessors in
brcmf_sdiod_sglist_rw.
On 11/14/2018 4:28 AM, Andy Duan wrote:
From: David Miller <[email protected]> Sent: 2018年11月11日 8:34
[ As I am trying to remove direct SKB list pointer accesses I am
committing this to net-next. If this causes a lot of grief I
can and will revert, just let me know. ]
[...]
I just have bcm4339 in hands, test the patch on i.MX7D sdb board with
bcm4339, it works fine with iperf testing.
Tested-by: Fugang Duan <[email protected]>
Thanks, Andy
Can you do one more check? Please insert brcmfmac with module parameter
debug=2 and let me know if the following log message is seen:
brcmfmac: brcmf_sdiod_sgtable_alloc: nents=X
If not seen, the driver does not go through the patched code.
My kernel don't enable debug and DEBUG and CONFIG_BRCM_TRACING, I add
the debug info in the brcmf_sdiod_sgtable_alloc(), and the log show
the driver go through the sg path:
Log: brcmf_sdiod_sgtable_alloc: max_segs:128, sg_support:1, nents=35
Thanks, Andy
Works for me ;-)
I should better read the patch email. I tried to apply the patch to
wireless-testing, but it failed simply because the patch is already in
place through net-next as Dave mentioned. Anyway, it is good that it has
been tested to some extent.
Regards,
Arend
