Hello Tamizh, > This patch add ops for set_tid_config to support TID > specific configuration. STA information along with the > TID config change mask to notify driver that which configuration > needs to be applied for this current command. > If the STA info not available in the command then the > configuration will be applied for all connected stations > in the vif. TID specific noack configuration requires > aggregation disabled and rate for the data TID packets > should be basic rates. So, if the TID already configured > with noack policy then driver will ignore the aggregation > or TX rate related configuration for the same data TID. > In TX rate configuration should be applied with highest > preamble configuration(HT rates should not be applied > for the station which supports vht rates). > > Vif specific TID configuration will be applied for all > the connected stations except for the station which > already applied with the same configuration for the TID > through station specific command. Newly connecting stations > will be applied with vif TID configuration which will be stored > in ieee80211_vif. > > Testing: > * Tested HW: QCA9888 > * Tested FW: 10.4-3.5.1-00052 > > Signed-off-by: Tamizh chelvam <[email protected]> > --- > drivers/net/wireless/ath/ath10k/core.h | 7 + > drivers/net/wireless/ath/ath10k/mac.c | 602 > ++++++++++++++++++++++++++++----- > 2 files changed, 529 insertions(+), 80 deletions(-) > > diff --git a/drivers/net/wireless/ath/ath10k/core.h > b/drivers/net/wireless/ath/ath10k/core.h > index 27ec555..c25c426 100644 > --- a/drivers/net/wireless/ath/ath10k/core.h > +++ b/drivers/net/wireless/ath/ath10k/core.h > @@ -82,6 +82,9 @@ > /* Default Airtime weight multipler (Tuned for multiclient performance) */ > #define ATH10K_AIRTIME_WEIGHT_MULTIPLIER 4 > > +#define ATH10K_MAX_RETRY_COUNT 30 > +#define ATH10K_MAX_TIDS 8
Is there any reason why you don't use IEEE80211_TID_MAX here ? Regards, Sergey
