Initial frame exchange sequence has been changed for 9116 chip. Getting MAC address using EEPROM read frame will be once common device configuration is done and RESET_MAC frame is sending after bootup parameters confirmation is received, which are different from RS9113 device
Signed-off-by: Siva Rebbagondla <[email protected]> --- drivers/net/wireless/rsi/rsi_91x_mgmt.c | 38 +++++++++++++++++++------ 1 file changed, 30 insertions(+), 8 deletions(-) diff --git a/drivers/net/wireless/rsi/rsi_91x_mgmt.c b/drivers/net/wireless/rsi/rsi_91x_mgmt.c index 844f2fac298f..9eb60a5501a2 100644 --- a/drivers/net/wireless/rsi/rsi_91x_mgmt.c +++ b/drivers/net/wireless/rsi/rsi_91x_mgmt.c @@ -1766,15 +1766,26 @@ static int rsi_handle_ta_confirm_type(struct rsi_common *common, rsi_dbg(FSM_ZONE, "%s: Boot up params confirm received\n", __func__); if (common->fsm_state == FSM_BOOT_PARAMS_SENT) { - adapter->eeprom.length = (IEEE80211_ADDR_LEN + - WLAN_MAC_MAGIC_WORD_LEN + - WLAN_HOST_MODE_LEN); - adapter->eeprom.offset = WLAN_MAC_EEPROM_ADDR; - if (rsi_eeprom_read(common)) { - common->fsm_state = FSM_CARD_NOT_READY; - goto out; + if (adapter->device_model == RSI_DEV_9116) { + common->band = NL80211_BAND_5GHZ; + common->num_supp_bands = 2; + + if (rsi_send_reset_mac(common)) + goto out; + else + common->fsm_state = FSM_RESET_MAC_SENT; + } else { + adapter->eeprom.length = + (IEEE80211_ADDR_LEN + + WLAN_MAC_MAGIC_WORD_LEN + + WLAN_HOST_MODE_LEN); + adapter->eeprom.offset = WLAN_MAC_EEPROM_ADDR; + if (rsi_eeprom_read(common)) { + common->fsm_state = FSM_CARD_NOT_READY; + goto out; + } + common->fsm_state = FSM_EEPROM_READ_MAC_ADDR; } - common->fsm_state = FSM_EEPROM_READ_MAC_ADDR; } else { rsi_dbg(INFO_ZONE, "%s: Received bootup params cfm in %d state\n", @@ -1936,6 +1947,17 @@ int rsi_handle_card_ready(struct rsi_common *common, u8 *msg) case FSM_COMMON_DEV_PARAMS_SENT: rsi_dbg(INIT_ZONE, "Card ready indication from WLAN HAL\n"); + if (common->priv->device_model == RSI_DEV_9116) { + if (msg[16] != MAGIC_WORD) { + rsi_dbg(FSM_ZONE, + "%s: [EEPROM_READ] Invalid token\n", + __func__); + common->fsm_state = FSM_CARD_NOT_READY; + return -EINVAL; + } + memcpy(common->mac_addr, &msg[20], ETH_ALEN); + rsi_dbg(INIT_ZONE, "MAC Addr %pM", common->mac_addr); + } /* Get usb buffer status register address */ common->priv->usb_buffer_status_reg = *(u32 *)&msg[8]; rsi_dbg(INFO_ZONE, "USB buffer status register = %x\n", -- 2.17.1
