On 12-12-20 7:54 PM, Lai Eddy wrote:
Hi , I'm using yocto 1.3 on jasperforest BSP, have build the USB flash drive and boot on target h/w successfully. after trying to add "igb" for intel 82580DB network controller support in jasperforst.conf +’KERNEL_FEATURES_append = "features/igb"’, build done but after the target boot, there's no eth0 port present how can I check if the igb driver is inclued and loaded in the target?
I'm out of the office at the moment, and doing this from memory, so sorry for not being completely precise. You can check to see if the kernel options were picked up and made it to the build by looking at the linux build directory and the .config, are you options present in the final .config ? If they are, then you'll also see the .ko's in the build tree, and those same modules packaged in the linux-yocto deploy directory. That means the modules are available. But they won't be autoloaded on boot unless you have an init script that modprobes it, or you have a recipe that makes use of the oe-core module loading framework. So I'd suggest a build, boot and a manual modprobe of the igb module. That will check everything that I mention above, and you'll have the dmesg output to tell you if something has gone wrong while inserting the module (versus a build time issue). Cheers, Bruce
or where’s wrong with that igb driver? _______________________________________________ linux-yocto mailing list linux-yocto@yoctoproject.org https://lists.yoctoproject.org/listinfo/linux-yocto
_______________________________________________ linux-yocto mailing list linux-yocto@yoctoproject.org https://lists.yoctoproject.org/listinfo/linux-yocto
