Hello,
first, I should admit, that I'm getting these lines on boot:
ieee802154hardmac ieee802154ha
rdmac: Added ieee802154 HardMAC hardware
pxa27x-udc pxa27x-udc: USB reset
ieee802154fakelb ieee802154fakelb: Added ieee802154 hardware
Initializing ZigBee TTY interface
cc2420 spi3.0: no platform data
cc2420: probe of spi3.0 failed with error -22
I'm not sure, if it's important, but it doesn't look correct.
Then while starting the wpan0 I get this:
# iz add wpan-phy1
Registered new device ('wpan0') on phy wpan-phy1
# ip link set wpan0 address 11:22:33:44:55:66:77:88
ip: either "dev" is duplicate, or "address" is garbage
# ifconfig wpan0 up
# ifconfig
usb0 Link encap:Ethernet HWaddr 06:C9:FF:1B:5A:E0
inet addr:192.168.99.101 Bcast:192.168.99.255
Mask:255.255.255.0
inet6 addr: fe80::4c9:ffff:fe1b:5ae0/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:3013 errors:0 dropped:0 overruns:0 frame:0
TX packets:2096 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:1144307 (1.0 MiB) TX bytes:357364 (348.9 KiB)
wpan0 Link encap:UNSPEC HWaddr
00-00-00-00-00-00-00-00-00-00-00-00-00-00-00-00
UP BROADCAST RUNNING NOARP MTU:127 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:10
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
So, what am I doing wrong this time?
--
Respectfully yours, Alexander E. Gogolev
------------------------------------------------------------------------------
_______________________________________________
Linux-zigbee-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/linux-zigbee-devel
