I have seen the interrupt line going low forever with heavy traffic.
The at86rf230 driver has two isr, one for edge-triggered and another
for level-triggered interrupt. The latter uses
disable_irq_nosync/enable_irq which makes sense for level-triggered
interrupt. Otherwise the interrupt would be triggered again and again
until the scheduled work read the status register.
However I don't see the use of disable_irq/enable_irq with an
edge-triggered interrupt. Perhaps I'm missing something. Though I
don't see any harm using it anyway. As you said the interrupt should
be delayed until enable_irq() is called. In particular when
CONFIG_HARDIRQS_SW_RESEND is set.
David
2013/5/14 Alan Ott <a...@signal11.us>:
> On 5/9/13 11:19 AM, David Hauweele wrote:
>>
>> Disabling the interrupt line could miss an IRQ and leave the line into a
>> low state hence locking the driver.
>>
>
> Have you observed this? My understanding is that the interrupt won't be lost
> but instead delayed until enable_irq() is called.
>
> I got this pattern from the other 802.15.4 drivers. Perhaps my understanding
> is wrong.
>
>
>
>> Signed-off-by: David Hauweele <da...@hauweele.net>
>> ---
>> drivers/net/ieee802154/mrf24j40.c | 7 +------
>> 1 file changed, 1 insertion(+), 6 deletions(-)
>>
>> diff --git a/drivers/net/ieee802154/mrf24j40.c
>> b/drivers/net/ieee802154/mrf24j40.c
>> index 1e3ddf3..6ef32f7 100644
>> --- a/drivers/net/ieee802154/mrf24j40.c
>> +++ b/drivers/net/ieee802154/mrf24j40.c
>> @@ -603,8 +603,6 @@ static irqreturn_t mrf24j40_isr(int irq, void *data)
>> {
>> struct mrf24j40 *devrec = data;
>>
>> - disable_irq_nosync(irq);
>> -
>> schedule_work(&devrec->irqwork);
>>
>> return IRQ_HANDLED;
>> @@ -619,7 +617,7 @@ static void mrf24j40_isrwork(struct work_struct *work)
>> /* Read the interrupt status */
>> ret = read_short_reg(devrec, REG_INTSTAT, &intstat);
>> if (ret)
>> - goto out;
>> + return;
>>
>> /* Check for TX complete */
>> if (intstat & 0x1)
>> @@ -628,9 +626,6 @@ static void mrf24j40_isrwork(struct work_struct *work)
>> /* Check for Rx */
>> if (intstat & 0x8)
>> schedule_work(&devrec->rxwork);
>> -
>> -out:
>> - enable_irq(devrec->spi->irq);
>> }
>>
>> static void mrf24j40_rxwork(struct work_struct *work)
>>
>
------------------------------------------------------------------------------
AlienVault Unified Security Management (USM) platform delivers complete
security visibility with the essential security capabilities. Easily and
efficiently configure, manage, and operate all of your security controls
from a single console and one unified framework. Download a free trial.
http://p.sf.net/sfu/alienvault_d2d
_______________________________________________
Linux-zigbee-devel mailing list
Linux-zigbee-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/linux-zigbee-devel
